Directional interconnect cables

I generally agree with his comment:

"Reverse a wire and it takes a couple of days of use in the reversed direction for the wire to settle in and sound its best. This settling-in improvement is smaller in magnitude than the difference in sound from running the wire backwards, so you can tell immediately upon reversing a wire if it is in the best direction or not."

Except that I believe the whole thing can be explained by the dielectric charge. I "burn-in" my ICs and cables a couple of hundred hours and try to minimize the amount that I move them, so if I reverse one it's going to take more than a couple of days to recharge.

Just a theory. Unfortunately, most of this can't be measured, so no one that I know of has compared one directionality vs. another with sufficient burn-in between changing directions to neutralize the direction change.

If we believe it takes hundreds of hours for cables and ICs to perform at their potential, then any time we change direction we need to give the same amount of time before a comparison is valid, IMHO.

Dave

Wire is directional esp. solid core search some of Bob Crump's post here and else where

The experiment, performed with new(0 hrs) cables/interconnects, would be valid. Not hard to figure out. My theory concerning the chevron structure affecting the positive(compression generating) portion of the signal if a cable is reversed is based on the possibility of it acting as somewhat of a diode toward the signal. That would mean connected correctly, the positive(Compression) portion of the signal would pass unscathed/uncorrupted, the negative- less so. Perhaps I shouldn't have slept through so many sessions of Quantum Mechanics 101.

Buy favorite cable, install per manufacturer, sit back and enjoy..unless your an obsessive psychopath:)