Synergistic Research QLS-Which power cord to use??

In regards to Joeyboynj, I used to have a T3 on my QLS9 and a Precision AC on my Parasound 2205A power amp(220x5)RMS . It sounded good until I swapped them and noticed the soundstage width & depth open up dramatically. The sound was more dynamic & detailed, more full sounding. I'm not sure which was the positive result but I'm willing to bet it was probably the better Precision AC from the QLS to wall. Are you suggesting maybe a T3UHC or Precision AC on my Power amp??? Your thoughts....

REGARDS Bacardi

I think you have it right with the Precision AC from the QLS to the wall and the T3 on your amp. The T3 UHC was designed to power an entire system. The T3 was designed to power an amplifier or any other large single source. You may want to try a Hologram A on your amp if you really are looking for an upgrade. What power cords do you have on your pre and CDP?

I have a T2 on my PreProcessor and T2 on my CDP....

REGARDS Bacardi

Go with what sounds best. I would think the Precision AC on the QLS to wall is the way to go. If you ever wanted to upgrade. I would go with the Hologram D on your CDP.

I have found the Precision a strange pc. I tried the Precision AC on my H-Cat amp versus the Hologram A. There was no question that the Hologram A was best. Later I compared the Precision versus a T2 on my H-Cat line stage. The Precision was far superior although the T2 is a great buy. I guess I am going to have to get another Hologram A for the line stage.

I have a QLS-6 plugged into my PowerCell, but it mainly is used for the wall warts for the SR shielded pcs. However, my tt is plugged into it and has been greatly improved, but remember the OLS is plugged into the PowerCell.