need warm and LAID BACK hi-rez/focused power cord


I posted several months ago seeking recommendations for hi-rez, highly focused power cords in the tradition of the TG Audio Silver but with greater warmth or body. I did acquire a pair of Fusion Audio Enchanters and a VD Nite Platinum from the responses to my inquiry. However, after changes in amps, cd player, interconnects, and new Porter Ports, I find myself in need of advice again on the same matter. My system presently is: A Consonance Droplet 5.0 run directly into a Wyred 4 Sound ST 500 driving a pair of custom Legacy Focus clones using Eton drivers/midbass, metal dome mids & tweeters/NHT woofers. Both components are plugged into a PS Audio P 600 equipped with Porter Ports.
I have an Enchanter plugged into both the power regenerator and the CDP and a Wolff Gain with Oyaide Palladium/Gold plugs on the amp. Interconnects (balanced) are either Sunny Cables 1000's or Jungson Golden Dragons.
Speaker cables are Anti-Cables which I run directly into the speakers/crossovers bypassing binding posts.

My system is very detailed with very good focus and staggering dynamics. With good recordings, all is well and I'm quite satisfied. However, on some (many) recordings, horns, piano, and some guitar can some across aggressively. It has been recommended I replace the Oyaide plugs. Perhaps I will. What I would like are some recommendations on hi-rez, highly focused power cords that are to the laid back and warm side. I really liked the VD Nite Platinum but, it was too upfront for my system. Price is a factor in that I would like to spend $600 or less on the used market. Thanks in advance.
lcherepkai
Post removed 
Tvad has the ratings correct. Funny you should mention image sharpness and ambience. I recently replaced the MIT PPMFX capacitors in my Joule Electra preamp with Jantzen Z-Superior caps. While I am hearing improvements in all sonic parameters, image focus and ambience are absolutely astounding after this change!

Many cheap caps sound smeared and hard, quality caps reduce this by a much greater amount than cables, tubes and other tweaks IMO. If you are willing to change out the caps this may be your answer, this may also cost much less than all the cable changes.
I just checked out your amp, not familiar with it previously. It appears to use Wima and Muse electrolytic caps, those are good electrolytics, sill not up to good film caps. Wyred 4 Sound (Cullen circuits) does mods, check with them for possible upgrades in caps.

I also can't imagine that amp being responsible for the majority of your problem. ICE based amps are realatively warm, not biting. Could be your speakers, specifically those Eton metal dome tweeters.