2. cables
  3. 1235078874

need warm and LAID BACK hi-rez/focused power cord

I posted several months ago seeking recommendations for hi-rez, highly focused power cords in the tradition of the TG Audio Silver but with greater warmth or body. I did acquire a pair of Fusion Audio Enchanters and a VD Nite Platinum from the responses to my inquiry. However, after changes in amps, cd player, interconnects, and new Porter Ports, I find myself in need of advice again on the same matter. My system presently is: A Consonance Droplet 5.0 run directly into a Wyred 4 Sound ST 500 driving a pair of custom Legacy Focus clones using Eton drivers/midbass, metal dome mids & tweeters/NHT woofers. Both components are plugged into a PS Audio P 600 equipped with Porter Ports.
I have an Enchanter plugged into both the power regenerator and the CDP and a Wolff Gain with Oyaide Palladium/Gold plugs on the amp. Interconnects (balanced) are either Sunny Cables 1000's or Jungson Golden Dragons.
Speaker cables are Anti-Cables which I run directly into the speakers/crossovers bypassing binding posts.

My system is very detailed with very good focus and staggering dynamics. With good recordings, all is well and I'm quite satisfied. However, on some (many) recordings, horns, piano, and some guitar can some across aggressively. It has been recommended I replace the Oyaide plugs. Perhaps I will. What I would like are some recommendations on hi-rez, highly focused power cords that are to the laid back and warm side. I really liked the VD Nite Platinum but, it was too upfront for my system. Price is a factor in that I would like to spend $600 or less on the used market. Thanks in advance.
lcherepkai
lcherepkai OP
280 posts
 
Casouza----You're right about the speaker cables. I only use these (and I use the smaller gauge anti-cables) so I can bypass the binding posts on my speakers (I don't have any presently) and connect directly to the crossovers. Originally, I had the crossovers pulled out and I ran anti
cables from each driver out of the speaker to the crossovers located behind my amp and I had these connected with Electraglide Silver Ribbon speaker cable (Goertz Silver ribbons). That certainly sounded better but the EG cables were quite short. Eventually, I would like to install a couple pairs of Eichman binding posts and then go after better speaker cables but that is a long term project. For the moment, this is the best, temporary fix.
I'll probably upgrade the crossovers at that time. Oh, this is a never ending battle isn't it? I have had Kimber 4TC before and I like the anti-cables better. I think they have better detail and are more palpable. Still, you're right about upgrading this weak link. Thanks.--Lyle
lcherepkai OP
280 posts
 
Well, I'm waiting on an Oyaide SWO GX (gold plated outlet) to arrive and see if that takes the edge out of my system.
If not, I'll probably acquire either/both a Kubala Emotion and/or a Purist Dominus. My system consists of a CDP, an amp, and a power regenerator. Where would it be best to install either cable? Thanks all----------Lyle
sns
3,455 posts
 
The power conditioner feeds the most components, try there first.

I'm also not sure the Oyaide SWO GX is going to give you the more recessed soundstage you want. All the Oyaide's are more forward sounding than the Porter Ports in my system. You want laid back, natural, the Porter Ports are it. The Oyaide GX will be warmer tonally than the other Oyaides, this may be what you're looking for.
lcherepkai OP
280 posts
 
Update---I wanted to try a gold plated outlet to see if it would take some of the edge out of my system (only presents itself on some "hot" recordings with certain instruments) and found a SWO-GX and and R1 from Oyaide used here on A'gon. The GX pushed the soundstage forward and made the problem worse. However, the R1 has made a significant improvement. Soundstaging distance is about midway between the slightly laid-back Porter Port and the upfront Oyaide SWO GX. Detail is excellent as is tone with a relaxed feel that has taken 80-90% of the bite out of my system. I'm still going to install either a KS Emotion or Purist Dominus pc soon. Thanks for the advice!
rfogel8's avatar
rfogel8
192 posts
 
Ever consider the aggressive sound might be coming from your components or more likely those metal dome tweeters and mids in your Legacy "clones"?

Power cords and cables in general will only do so much and let's face it, they're often used as bandaids or tone controls as in your case.
More to discover