Heavy Power Cords

The IEC connector is one of the worst form of electrical plug and receptacle devices ever made. Why American manufacturers went with the European IEC connector is a mystery to me. Contact pressure between the male and female connector sucks. The USA NEMA plugs and recepts beats IEC connectors hands down.

Wow, that feels better.

At any rate I have wondered if an o-ring around the body of the IEC cord connector would help hold the connector in place. The o-ring would cause the two connectors to fit tightly against one another. Yep a bag of different thickness o-rings would cost about $25 bucks.....
Still wouldn't help the piss poor contact pressure though.

The IEC connector is one of the worst form of electrical plug and receptacle devices ever made.

OT: I vote for the 1/8" stereo mini-plug and jack. Followed closely by the 1/4" headphone plug and jack. Neither can be counted on to maintain contact in the event of the slightest jiggling, or after repeated re-insertions. But yes, the IEC is not too far behind. :)

-- Al

Easy,

Take a piece of black teflon heatshrink tubing (1/2" O.D. ?) carefully cut or trim it to the appropriate length with scissors or a razor blade and stretch it over the end of the power cord's IEC.

Some lube that dries will help slip it on easier.

I cut up cheap 7/16" thick foam work shop floor tiles and stack them horizontally for strong support under all my cables and especially the P/C's where they attach to the equipment.