Unconnected Drain Wires ?

Hi Jea48,

Since that is not my company I luckily don't have to explain it ;-), maybe they like the radio stations in Poulsbo, WA? I have heard before that that is how those lower end shunyatas are configured but I was unable to find that actually spec'd anywhere, maybe I am looking in the wrong place. Perhaps in certain system/situations an unconnected shield sounds better but you always run the risk of it acting like an antenna. In general connecting the drain to the wall will give you the best sound on a shielded cord in the vast majority of system.

In general connecting the drain to the wall will give you the best sound on a shielded cord in the vast majority of system.
Cpk

Cpk, thanks for your response.
As I said in an earlier post my understanding of connecting the shield to the source end of the power cable is to bleed off RFI to earth ground and stop the shield from acting like an antenna.

Then I ran across the Diamondback shielded power cable. I borrowed one from a dealer in my area and tried it on my CDP. Not a bad power cable for the price.

At any rate the drain wire is not connected at either end of the cable. And as far as I know no one has complained about RFI problems.

And here is some food for thought.... How about audio systems out there with shielded power cables that have a ground cheater/s connected to them because of a ground loop hum problem? Or systems connected to an old two wire house electrical branch circuit without an equipment safety ground.
Though in the case where an equipment safety ground is not being used there would still be a conductivity path back through the equipment grounding conductor of the power cord to the equipment chassis signal ground,... but not earth ground. Wow, LOL.... What is your opinion on that one...
Jim

Hi Jim,

What I make of it is everyone’s system and situation is different. If the weren't it would be much easier to design a line of cables that work well in all cases. For example Mr. Hansen of Ayre fame IIRC runs with all the grounds lifted on all his gear, if you search Asylum there are a number of his posts concerning this. He says sonically it is superior. I run with all my frontend floating and my amps grounded but then again none of the cables that I make are shielded and I have no problem with noise or hum.

What I heard when listened to a cord with a floating shield was a reduction of air in the soundstage, in a system that these level of cords may be used in that might translate into a reduction of some HF nasties

Yes Charles does float his entire system (and his older home has ungrounded outlets) but it is also worth noting that Ayre double insulates their component chassis' thus making the endeavor safer.

Chris, I was thinking of floating the ground on my front end by disconnecting the components internal ground wire, rather than doing it at the AC plug end on my Tel Wire cables. Any thoughts on this? If I had to do it on the AC plug end of the Tel Wire cable is it easy enough to do?

Hi Tony,

My suggestion would be turn off breaker feeding that outlet then just disconnect the ground at the receptacle. You could do it at the AC plug but I don’t think you want an unconnected ground wire flopping around in the plug body. Hey what length speaker cable do you use?