I also own the Audiodharma Ozzy. And the Manley skipjack.
What some folks fail to realize is that cable burn-in is not just strictly dependent on reaching conductor vs. dielectric entropy. Burn-in MAINLY facilitates annealing between the crystalline structures of the metal. What this means is this (this is going to be HEAVY so prepare yourself) IF YOU DISCONNECT THE ALREADY BURNED-IN CABLE FROM YOUR SYSTEM, YOU HAVE JUST ELIMINATED THE BURNED-IN ADVANTAGE FROM THE CABLE! Any bending of the cable in any way will remove the tight bonding between the crystals. You would have to burn-in again. And yes, you guessed it, that means you cant do it on the cooker THEN remove the cable again. DIELECTRIC SYNERGY IS NOT AFFECTED THIS WAY. Once dielectric absorption has become stable, its good to go (for the most part...I'm not getting into this right now.) Ozzy, you have made some suggestions to me, allow me to make some to you. Familiarize yourself with my components. This should give you an idea of their resolving capabilities. Then, read up on the Skipjack. Afterwards, look up annealing on WIKI...and make sure to locate the correct definition. You could also read a little on entropy theory. But, its very confusing. It basically means the potential state of system, when the statistical factors of order vs. disorder are calculated. I forgot to mention that I am also a musician. Not professionally, but by choice. I was trained in Classical piano, but took up guitar and drums for fun. Guitar...not so much (imitating BORAT), drums...WATCH OUT VINNIE COLAIUTA!
What some folks fail to realize is that cable burn-in is not just strictly dependent on reaching conductor vs. dielectric entropy. Burn-in MAINLY facilitates annealing between the crystalline structures of the metal. What this means is this (this is going to be HEAVY so prepare yourself) IF YOU DISCONNECT THE ALREADY BURNED-IN CABLE FROM YOUR SYSTEM, YOU HAVE JUST ELIMINATED THE BURNED-IN ADVANTAGE FROM THE CABLE! Any bending of the cable in any way will remove the tight bonding between the crystals. You would have to burn-in again. And yes, you guessed it, that means you cant do it on the cooker THEN remove the cable again. DIELECTRIC SYNERGY IS NOT AFFECTED THIS WAY. Once dielectric absorption has become stable, its good to go (for the most part...I'm not getting into this right now.) Ozzy, you have made some suggestions to me, allow me to make some to you. Familiarize yourself with my components. This should give you an idea of their resolving capabilities. Then, read up on the Skipjack. Afterwards, look up annealing on WIKI...and make sure to locate the correct definition. You could also read a little on entropy theory. But, its very confusing. It basically means the potential state of system, when the statistical factors of order vs. disorder are calculated. I forgot to mention that I am also a musician. Not professionally, but by choice. I was trained in Classical piano, but took up guitar and drums for fun. Guitar...not so much (imitating BORAT), drums...WATCH OUT VINNIE COLAIUTA!