how to put together 6awg thhn speaker cables

A good idea would be to pick out the spades first by getting a few to sample. Check them out on your speakers binding posts and then either crimp or solder them onto the ends.

Crimping should be good enough. thereafter, or prior to the spade attachment, slip some heat shrink onto the cables so the oxidation where the connectors are attached is impeded.

It comes in sizes and colors so you can tag each end as to polarity. Putting a slight twist to the pairs and adding some 1/4 inch sensing tape now and then to the length of the cables should also make them more manageable and neater in appearance. Sensing tape comes in several colors.

I hear there are socks for DIY speaker cables too... somewhere online.

If the project doesn't work out satisfactorily for you, simply add plugs to either end and you'll have that high current extension cable or power cord, you've always wanted! lol

Nah, I just find it hard to believe you can get the best sound from cables from home depot/lowes.They got crappers & sod, a speaker cable? who knew.If possible does not bare wire have the potential to deliver the best sound possible.That is what I was looking for.SUPRA. GREAT PRODUCT.

The wealth of DIY on the inter-net avalible to the listiner to try for oneself.I havnt seen too much 6ga used.I,m not sure if they could answer THAT kind of a question,and on short runs?Wouldnt matter the dia. of the speaker cable going in,what it bottle necks down to the internal wiring dia.Why such the large size.Size matters,but this is audio.It may not apply. Black & DEcker?WHO KNEW.Thats like,whats under the hood,kind of info.The T.V. tray tops and concrete blocks are working great.there are many roads but only one sound.I,d still buy from a place into the stuff I am into,AUDIO.Paints,bug sprays,crappers,oh could you answer a audio question for me.You can hope :}