I make every effort to have power cords not touch the floor using Suspendors, a ceramic isolator. I also seek to have them cross each other at right angles or close to it. Of late I have been using charged cables which might be insensitive to being on the floor, etc. I have not found that to be the case, less sensitive yes but not insensitive.
Power cable management
Is there any consensus on what to do with power cords that are too long? I figure the options are:
1). Coil neatly
2). Wrap neatly back and forth kind of like a bow tie
3). Leave as a rats nest and try to ignore it
I am currently employing option 3 but would like to staighten it up a little. This is for relatively flexible captive power cords on some older equipment I have. I also have some stuff that takes UECs but my aftermarket cords are made to just about the right length so there isn't really any excess to worry about.
1). Coil neatly
2). Wrap neatly back and forth kind of like a bow tie
3). Leave as a rats nest and try to ignore it
I am currently employing option 3 but would like to staighten it up a little. This is for relatively flexible captive power cords on some older equipment I have. I also have some stuff that takes UECs but my aftermarket cords are made to just about the right length so there isn't really any excess to worry about.
- ...
- 9 posts total
- 9 posts total