At what distance are balanced XLR cables needed?


I've been looking for a new preamp for my 2 channel system, and I'm debating whether I need balanced inputs if I want to eventually connect it to my home theater processor. I plan on moving soon, so I can't say for sure what distance I would have between the two systems. My preamp options quickly dwindle if I require XLR cables.
hoffer71
If Zone 2 is really 51 ohms you could use that output. 300 ohms is a bit high for solid state but it will probably be OK.

Bear in mind that you can spend an arm and a leg for unbalanced interconnects made with exotic wire. Balanced interconnects don't need exotic wire, and might cost you less.
Eldartford - you can spend arm and a leg for a balanced IC as well. They're also made of fancy materials - both metals and insulation. There is no reason why it should be different IMHO. Purity of metal still applies since impurity reside between crystals while insulation material directly affects capacitance and dielectric absorption.
The superior connectiviity of a balanced connection makes it an easy choice--if you have that option. And while Kinjanki makes a valid point, reasonably priced XLR cables are widely available. A well-known manufacturer touts Belden cables with decent connectors for his very pricey gear. If it's good enough for him... Kal's comments are certainly valid also. Try borrowing cables from the Cable Co. The only downside is that they probably have limited choices in the lengths discussed. Blue Jeans Cables might be a good, low-cost option for you. Just my $.02 Good luck!
Kijanki.. And you can pay an arm and a leg for little stones.
Atmasphere, whose opinion carries a lot of weight, has suggested that fancy wire is of little value in balanced interconnects.
I ran a 30-feet Purist Dominus RCA-RCA IC from Aesthetix Callisto Sig line stage to CAT JL-3 amps for a few years and had no problems with noise, radio station pickup, etc. My experience with this one setup nullified many of the theories regularly reported here. You won't know if it a cable works for you unless you try it out yourself.

Atmasphere, whose opinion carries a lot of weight, has suggested that fancy wire is of little value in balanced interconnects.
I value the contributions made here regularly by Atmasphere. But my experiences about balanced and single-ended cable differences significantly differ than his reports here. Once again, don't get too attached to the blanket statements often made here, but rather try many cables for yourself.