XLR or RCA?

I used to own the McIntosh MC275 amp. Even though it is not fully balanced, I tried both RCA and XLR cables (Crimson Music Links) between it and my preamp at the time, an Aesthetix Calypso. I preferred the sound with the XLR cables -- I thought my system sounded fuller, with better bass than with the RCA cables. This probably had more to do with the Calypso, which is fully balanced, than the MC275, which is not.

In any case, why not just borrow XLR cables from the Cable Company or buy them from Music Direct, which offers a 30-day money-back guarantee? If you hear a difference and like it, then buy the XLR cables. If not, return them.

OK, in theory from this discussion should I take it that, all materials being equal, XLR cables are more resistant to noise than RCA cables? That noise can be both a function of cable length and EMF environment? And furthermore should I assume that more complex construction, at least in terms of shielding, should reap bigger benefits for RCA cables versus XLR cables? But what about wire configuration (I.E. metallurgy, thickness, shape) and dielectric composition? If you believe these are relevant at all, wouldn't they be relevant and affect the "sound" for both types of interconnects?

I understand and accept that many of these variables are highly application dependent (gear, physical location relative to EMF, ears and beliefs of the listener), and there is no substitute for "try before you buy", but I am just looking to see if I have grasped the relevant information in the discussion above...

kn

Yes, XLR is more resistant to noise. Shielding plays bigger role in RCA since XLR has inherent noise rejection by usage of twisted pair. Materials still plays role (capacitance, dielectric absorption, metal purity etc.)

On the other hand XLR often requires additional stage to "make" inverted signal. In electrically quiet place RCA can sound better IMHO (but I still like locking connectors). It is also application depended, as you stated. XLR has shield grounded on both ends creating possibility of ground loops in some systems. Also XLR is most likely more expensive - why to spend extra money if you cannot hear the difference?

My suggestion to OP is not very technical although I'm sure much of what has been said above is correct.

Borrow two sets of the same cable from The Cable Company, one XLR and one RCA. Listen to both and decide which sounds best to you.

Longer runs of IC's should use XLR. The influences of shielding, insulation, etc. is completely dependent on the entirety of the cable design. In the end, if your IC length is 2m or less, try them both and see what you like. Also, if you are looking to really hear what advantage balance cabling might offer, your system needs to have balanced circuitry stem to stern. Otherwise, as you understand and accept, there is no substitute for listening and finding what you like, so have at it! And don't forget to enjoy the tunes along the way.