audiophile grade sub panel and breakers?

I did a little research on this when I upgraded my panel during a renovation. I hear the Square D panel with the copper bus bars is a good way to go. I ended up with a Murray panel and had copper bus bars ordered as an upgrade. Make sure your electrician does a good job grounding the whole system and consider mounting an Environmental Potentials waveform correction device to the panel--excellent surge/lightening protection and also eliminates noise and hash in the line.

Good luck.

Thank you Dodgealum. I appreciate your response.

I run a 100 amp 8 position Square D QO sub panel. I use four of the eight 20 amp breakers and keep all four on the same phase. Better grounding at your electric meter helps alot too. I'm using two 10' 3/4" grounding rods, spaced 10" apart, and connected to the electric meter with a 3 gauge grounding wire. If your electric meter grounds directly to a copper water pipe, I'd recommend beefing up your grounding wire. Good luck! Stan