2. tech-talk
  3. 1429116719

DIY Stereo Rack

I want to build a music system rack but get a headache after trying to chose what route to go. Is the hardest densest wood like ash or walnut best. Or something softer? I was thinking of using countertop cement for shelves. My thinking being the harder it is the easier vibrations transfer. Cement being not so dense may not transfer vibrations so readily. If styrofoam was stronger why not use blocks of it for super vibration isolation? Thanks for any insight you can provide. Bob
guiddog
jdoris
972 posts
 
Below is a thread about building a rod and block rack to which many people, including Timrhu, contributed.

Mine is in maple; I note, with amazement and dismay, that it's been almost ten years. In contrast to its builder, the rack has held up just fine. :)

Good luck!

John

http://forum.audiogon.com/cgi-bin/fr.pl?htech&1158841915&read&keyw&zzflexi-type
peter_s
1,348 posts
 
Is maple butcher block ok relative to solid maple? You can get good deals on premade butcher block products.
nonoise's avatar
nonoise
10,897 posts
 
I don't see why butcher block wouldn't work. My Timbernation stands shelves are butcher block constructed and work just fine. I'd prefer to see the block intended before going for it as there's butcher blocks out there and then there are butcher blocks out there.

All the best,
Nonoise
jafreeman's avatar
jafreeman
689 posts
 
Maple, oak, birch, cherry--a good woodworker can use any wood you like, and in terms of board feet, you won't need that much, so cost differences between species should not be large. See my pics for stands built for me by a good friend and master woodworker. He made the legs and aprons, tops are then placed separately. This allows for easy shipping and use of isolation pads, etc.---very nice--made in the Twin Cities.
kwa69's avatar
kwa69
19 posts
 
I've made a few system racks and amp stands for me and a few few friends using different solid hard woods and laminates over the years.They were all nice and did the job but the last set I made for me out of Plexiglas turned out the best the weigh alot no vibrations from subs getting to my system.The only problem is the Plexiglas is a little expensive but if you can find a dealer that will sell you small 2'buy 2'pcs its alot cheaper. Anyway just a thought check my system for picks.
More to discover