If you want an alternative to using exposed threaded rods as the posts, try t slot aluminum extrusions. You can put the threaded rod through that and sandwich the top and bottom shelves together. If additional shelves are needed, there are accessories you can get or be creative to put them in.
DIY Stereo Rack
I want to build a music system rack but get a headache after trying to chose what route to go. Is the hardest densest wood like ash or walnut best. Or something softer? I was thinking of using countertop cement for shelves. My thinking being the harder it is the easier vibrations transfer. Cement being not so dense may not transfer vibrations so readily. If styrofoam was stronger why not use blocks of it for super vibration isolation? Thanks for any insight you can provide. Bob
- ...
- 18 posts total
Guiddog - I've tried some of the hardwood materials suggested above and also granite and MDF. The problem I found with all of them is they all tend to vibrate at some point in time if they are not "treated". One solution is to construct each shelf as a "sandwich" - i.e. between two layers of shelving material place a layer of the foam rubber material used to line drawers - the stuff with all the holes. The sandwich significantly reduces vibrations in both layers. Another approach that is easier to implement, is to get a sheet of sorbothane and apply it to the underside of the shelf. Provided the underside of the shelf is smoothly finished in some manner (like urethane) as the sorbothane naturally adheres by vacuum, so it can easily be removed without leaving any residue. You can easily experiment with the alignments i.e. either the square sheet aligns with the front/sides/back of the shelf or at an angle might be more beneficial. Re-applying a sheet may cause it to lose it's tackiness, so simply wash with plain water under the tap, or better still wipe with isopropyl alcohol to restore it. Either of these treatments will significantly reduce the vibrations in any shelf. A 1/10" thick sheet of sorbothane sheet is all that is required - Thicker may not improve it's effectiveness - but will cost you more Sorbothane sheets are available from Amazon/Ebay for around $25 for one square foot and is widely used by the HVAC industry on furnaces, plenum's etc. to curb noisy installations Good luck with the stand :-) |
Here's mine. I used maple with stainless steel tube and threaded rod for the uprights. The tubes are filled with sand and are totally dead. This is not for everyone as the construction required a good deal of machining (this could never be built with basic hand tools), but if you can do that sort of thing, go for it. If not, wood slabs with simple holes drilled through them with threaded rod will work. Building racks is not a science. Nobody knows what material is "best." Choose what is available and what you can work with and have fun. http://forums.audiogon.com/cgi-bin/fr.pl?vevol&1142743470&read&keyw&zzyou=enjoy=mystuff |
Ketchup, great stand. Both the process and the result must be very satisfying. I agree that the hardwood shelving and threaded rod approach seems one of the most easily built, cost effective, practical, vibration free options. I was going to go this route, however got a budget Target stand which I filled with sand (took a long time as sand was poured through the threaded spike holes) and replaced the plywood shelves with 2 maple. |
- 18 posts total