Latest comments on PS Audio PP?

My Krell amp sounds great plugged into the dedicated runs made for my audio system with a very good shielded filtered power cord. ( I cannot imagine paying for the 1200 so that I could plug my amp into it ) But I cannot ever listen to my system anymore unless the Preamp and CD are plugged into this. It is amazing PP300. But maybe I had better ask Steve. It might just be all in my mind. And Now I am out $1300. AAARRRRGGHHHH!!!!

FYI, I was told that the transformer boards on the P300 had a batch(s) with reversed wires on the transformer board which resulted in a switch between the neutral and line(hot) and subsequently out of phase with increased AC polarity. I checked this and low and behold, on my unit it was true. I popped the bottom, switched the neutral and line, and VOILA, no more boomy bass, better imaging and soundstaging, etc. I thought this was BS. I stand corrected, phase is important. Those of you with P300's may want to check, it made a not so subtle difference in my system.

Sorry, that should read increased AC potential, not polarity. As Bones said to Kirk," damnit Jim, I'm a doctor, not a magician." And I'm not an electronics whiz, obviously, but I can hear, and the above is true.

Well I know it's been a while, but I just received the P1200
for the 300S and I am now even more spoiled and don't want
to listen without it in the system. There is a much better
sense of staging and clarity and less glare, but no loss of
dynamics which is everything I had hoped for. I've spent
thousands on equipment over the years with not as much improvement. The only thing is that at extremely high levels to get the SPL similar to a live peformance it does get near the limit of 1400W and then would shut down. I am going to install a 220V line which will increase the limit 200-400 watts of balanced power for the P1200. I think that will do the trick. BTW going back after listening made the system sound like a "boom box" and I could not enjoy it the same.

Thanks for the update.