mods for Adcom GFP-750

Sean and SDcampell, thanks for your inputs. Its good to get constructive opposing views on the same subject. I'm considering modifying my cd player, Sony SCD-777ES SACD. What is the prefered way to route internal wire and which internal wire works best (Cardas, Wonder, Harmonic, Silver)? Was wondering in order of bag for the buck which components are usually better to replace in the power supply and analogue output stage circuit? Capacitors (Black Gates), Resistors (Caddock or Vishay), or diodes (Harris Fast Soft Recovery)? Does it pay to attach the deflex sheets to the top plate of the chassis? Since my power transformers are not shileded like the SCD-1, does it pay to buy the TI shielding and "apply it" to the transformers? Thanks in advance for your inputs. Mike

I do not like to bunch wires together ( especially power supply and signal wires ). Spread them out as much as possible. In terms of "re-wiring" something internally, keep in mind that this WILL alter it's tonal balance to a noticeable degree in most cases. This can be taken advantage of to some degree if you know what your doing and working with. As to specific recommendations of brand names, i won't / can't do that. There are just too many variables involved, especially the one called "personal preference". As to the various solders that i've worked with, Wonder is by far the easiest to work with. As to which one "sounds best", i don't know. I've read that Jenna labs did a test and they came away with the opinion that the Cardas sounded the best. As you might guess, that is what they use on all of their cables. I have used it many times before and found it slower to melt, slower to form and easier to make a bad connection with. I also like to take detailed notes when doing mods, as this way you can always "back-track" should you need to. There are some things that just don't work out the way that you think that they should. Being prepared for that will never hurt you. Sean
>

Sean, thanks for your input. I'll remove the product names and just ask the questions in a generalized way. In terms of "bang for the buck" which components are usually better to replace in the power supply and analogue output stage circuit? Capacitors, Resistors, or diodes? Please give order of biggest improvement to least improvement. Does it pay to attach the noise damping and RFI/EMI blocking sheets to the top plate of the chassis? Thanks, Mike

I work with radio communications gear and most of my audio based "experimentation" has been on some specific power amps and mostly speakers and DIY cables. I'm currently "gutting" some preamps and will consider this to be a "learning experience" in this area. As such, i will say that there is no ONE thing in ANY design that is a cure all unless the product is really just underdesigned to begin with. From what i've found, "modding" or "tweaking" gear is kind of an accumulation of a bunch of small steps forward that add up to a long and pleasurable walk down music lane. Most of it is trial and error based and that's why it is important to be able to reverse your "mods". Even the experts run into "why doesn't this work right" type of situations. As to shielding, i would try that in your sources, especially digital. I have found that my DAC's are quite susceptible to RF based interference. Other than that, let US know what YOU find out.... : ) Sean
>

Obviously the individuals against mods here take a flat earth view on the issue. as a close personal friend of
Stan Warrens i have heard 100s of his mods many have been done on adcom gear and all i can say is you don`t know what your missing if you haven`t listened to one of his pieces.
If an individual knows what he`s doing and what to do it to
the result`s can be wonderful.
most of his mods are less than $300.00 and more often are around $160.00