digital and interconnect cables burn in

As an electronics engineer, maybe I can clear up some misconceptions above. Yes Radioman, it's OK to have the system on, except the amp - good breakin method for interconnecs. But obviously this will not breakin the amp, the power cord for the amp, speaker cables, or the speakers. A tuner as signal-source is a great breakin tool for interconnects. CD player on repeat-mode works too, but for prolonged breakin you're wearing out the mechanics. However, you must have signal-current flowing through the cables. For current to flow through the cable, you must have a load connected. An amplifier input still provides that load, whether it's powered on or off. But in the case of a preamp input, the jacks which your cables are plugged into must be selected (ie: if plugged into aux 1, then your preamp input switch must be selected on aux 1 for a load-termination to appear at those jacks). Cable breakin boxes are another alternative, but are pricey, & will see little use for your $ unless you frequently change cables or hardware. Some dealers have these breakin boxes, & will do this for you if you buy cables from them (Granite Audio does this). I've been through this experience several times. The most aggravating was with some expensive Synergistic interconnects, which kept going bright-dark-bright. I finally ran them from my tuner into a dummy load for a month, then all was fine & these are great cables. The dummy load I used was a cassette deck's inputs (rarely used at our house anymore). You can even buy some cheap female RCA's at Radio Shack & solder 47k-ohm terminations across them for use as dummy loads. Feel free to inquire further if you're still unsure; email me via member-lookup & I'll be happy to assist.

Bob, That was most clear and helpful. I will certainly give my CD player a rest next time I break in interconnects. As Fpeel asked, what about speaker cables?

OK for speaker cables you have several options. You can play the system continuously at rather high levels when no one is home; allow for some consideration if you have pets though. You can use a break-in box, but the caveat here is to use caution if you have MIT or similarly terminated cables, because (some) breakin boxes apply DC, which will blow up the terminations, per MIT. You can setup a cheap garage or basement system & play the radio; face the speakers together & wire them out of phase to cancel some of the racket. You can make yourself a 4-ohm or 8-ohm dummy load out of some power resistors (must know ohm's law of series-parallel resistances to do this) or maybe just get 2ea. (1 per channel) 5 ohm or 10 ohm 20 watt power resistors, whatever is readily available, and some healthy-gauge clip leads. Cliplead the dummy loads to the ends of your speaker cables that you are breaking in, & absolutely use some electrical tape to ensure against short circuits! Death to your PA if you're not careful... Crank up the power partway & check the loads at intervals to ensure against overheating the resistors. They can be allowed to get nice & warm, but not blistering hot. Don't burn yourself, & don't look here for liability if you mess up (this is only my disclaimer for self-protection, even though it's free advice). The question regarding digital interconnects is a bit different. You must repeat-play the CD player, but it's not necessary to listen, or have anything other then your outboard DAC connected as a load termination. DAC power may be on or off - matters not.

Thanks Bob.

 

Hi Bob, I just want to burn in my new RCA Digital Cable. So as you have mentionned to bmpnyc, I should power on my CD transport, that is connected to my integrated amp, that is equiped with a built in DAC. So I would select the CD Transport on my integrated amp. My integrated amp would it be better to power it On, with No volume, or just a little volume; or let it on Stand By would be OK too ? Do you think that 100 hours would be a good burning period ? Thank you.