Cable / Upgrade Recommendation


I am consider upgrading to new cables for my 2-channel system(Adcom GCD 750 / Morrison ELAD / Audiosource Amp2 bridged / NHT VT1.2 / MIT T2 cables), and I am not sure which cables to try. The system sounds a bit bright, so perhaps cables with warmer characteristics? I understand that the T2 are already on the warm side; maybe I should consider upgrading something else? FYI, I listen to mostly jazz and classical.

Thanks in advance for any advice!
mgs
I would suggest PowerSnake power cords, I just purchased one, it make a vast improvement in sound on my system
Hi No_Money,
Sounds like we share the same belief that using cables from the same mfgr/quality/model give better synergy within the system. How do you like the Transparents? I thought about trying them but they are currently a little out of my budget. May I ask which particular model of Transparent cable you are using? Bob_bundus is indeed correct; I am using MIT T2 speaker cables (again, synery within the system), and following the above advice I think I will get those "garden" cables replaced first by a pair of T2 ICs, as well as an AC power conditioner, before I start fine-tuning.

Again, thanks you all for the advices and for elaborating the details!
Just another 2 cents I just played with cones under the HTS 2000 power conditioner and the results prompt me to share this with you. More clarity....
I do have Terminator II biwires and found them very good in overall balance in my system.
Power is an area I suggest you to investigate.
Regards
I found similar (slight) results getting the power center off the floor. A better conditioner than a Monster HTS2000 will yield even better results. Look into Vansevers or Chang Lightspeed. I had a similar problem originally and like a few others, a pair of MIT T2 did the trick. Mine are the Bi-Wire ones. What also help was when I picked up a used Nordost SPM cable and put it between my preamp and power amp; and then again later putting Siltech interconnects between the CD player and preamp.
Sorry about forgetting to mention this before...I am also using Bi-Wire version of T2 (8 ft.) between the NHTs and the Audiosources.