2. cables
  3. 994944780

replacing Audio Research power chords

I have an Ark Ls 2 MKII preamp and D-200 solid state amp

Both of these are factory wired and not removable chords. Does AR or anyone else do mods on the AR for removeable power chords.

The AR factory chord is probably much better than most standard chords but I'd think it could be improved on

AR's later models do have have removable chords

ANyone had any experience or input on this end

thanks

TOm
128x128audiotomb
dem
79 posts
 
I had an ARC dealer tech replace the factory PC with IECs to a V70 and a REF1 for about $50 per unit, but you could probably get it done cheaper if you shop around.
bob_bundus
1,834 posts
 
IEC's and chassis punches are available from Parts Express. Ground is not really a big issue as long as you replicate the original circuit; perhaps not even then?
vincehoffman's avatar
vincehoffman
50 posts
 
The last 2 posts are much more in line with reality. The IEC connector re-fit is no big deal at all. Any competent tech that works on quality gear can do it for you and for a whole lot less than $350 bucks! I just had 20 amp IEC receptacles retro-fitted to my Classic 150's. My old preamp, an LS2B, was long run with my favorite cord/conditioner, the Foundation Research LC1, hard wired in place of the original.

Happy Trails!
Vince@Freewheel
More to discover