Balanced vs. single-end RCA's - A Beginner's question


Due to the need for 50 foot length cables to my monoblocks, I first purchased Transparent's Ultra RCA's. However, after discussing the benefits of going with "balanced" cables, I traded in my RCA's for Transparent's Utra balanced interconnect. They literally doubled my cable "investment".

- Will it be worth the price?
- What should I expect? I'm hoping for an overall sound improvement and greater bass response.
- Any and all comments about the system below would be appreciated. I'm still learning...and may need a second job to afford this great hobby.

Amps: Classe CAM-350 monoblocks
Preamp: Classe CP-60
Speakers: Martin Logan's Prodigy
Speaker Cables: Transparent's Music Wave plus bi-wire 8'lengths
Interconnects: soon-to-be Transparent MW Ultra - 50 foot/side.
CD Player: Rega Planet 2000

Music: Jazz, pop, orchestral...Steely Dan,including anything by either Fagan or Becker... Beach Boys, Eagles, Pat Metheny Group, Everthing but the Girl,
128x128gerryn
gerryn: were your rca-terminated ic's noisy or did they have apparent rf problems? if you answer "no" to both parts of this compound question, then you'll likely not experience a sonic improvement with the xlr's worth your investment. BTW, i do hope, for your sake, that my surmise is wrong. you've got a very nice system for someone who regards himself as a "beginner." -cfb
From a purely engineering standpoint, a cable run as long as you have clearly warrants balanced cables. Very long runs are one of the primary reasons that pro audio gear uses balanced interconnects.

Whether it's "worth the money" is a question only you can answer...but please post your assessment after you install them. I'd be curious to know what differences you do notice.
Cornfed: Thanks for your reply and questions. I did experience some noise that I'm still not sure are a result of the RCA cabling or a phasing problem. According to my dealer, the speakers/amps may be on a different "phase" than that of the pre-amp/CD player. He tells me that they need to be on the same phase. Do you know anything about this subject?

I must say that since the Martin Logan's need to be plugged in, I do hear a very faint, mid-range hummmmm when there's no signal going to the speakers.

thanks