Heat Shrink Tubing - How ???

A hair dryer will work. I also tried a candle, but you have to hold the tubing well above the flame or you will get smoke marks on the tubing. The best way is to get a heat gun - they sell as low as $19 - from your local hardware or Sears.

Move the wire racks of a kitchen oven to allow yourself room. Preheat an oven to 400 degree (F). Hold the wire end (just off the head shrink) with a pair of tongs.

Open the oven door. (careful, there will be a blast of hot air) Insert the tongs holding the wire. Do not allow the wire to touch anything. The heatshrink should do its thing within 3-10 seconds. Remove from oven as soon as the shrink has shrunk.

Good luck.

P.S. You could also use a heat gun, available at Sears or Home D.

I use a std soldering iron to gently rub the heat shrink tubing to start the reduction process.This way you can also "form" the tubing around the wire..etc. as the tubing shrinks.

Ken

Lighter

Thanks Folks !!!