alternate method of bi-wiring

I have been biwiring for at least 10 years;still don't have the terminalogy lingo down.Most all that time I had 2 complete sets of wires. --Doubled up on the amp posts. EACH and EVERY time I started with run and jumpers; EACH and EVERY time the improvemnts ,adding the second run were huge. --This applies to using Analysis jumpers, before adding the second run, as well. And yes a quality single run with jumpers,betters less quality bi wires.

When I was not bi-wiring, I pulled my stock jumpers off and replaced it with decent cable. Of course I had better sound that way. I guess my rule of thumb for jumpers is this: Buy the speaker best speaker cable you can afford, then buy two feet of the next step up in the line to use as jumpers.

Here's the way I know it.

Single bi-wire: Each stereo set has two cables. Each cable has one + and one - termination at the amp end and two +'s and two -'s at the speaker end.

True bi-wire: This is a standard stereo pair of speaker cables X two. Two completely individual sets of stereo speaker cables. I use this method as it offers the convenience of versatility whether it be changing the speakers or the cables themselves.

Shotgun: Two runs of cable instead of one.

Shotgun bi-wire: First, look at this pic: http://www.virtualdynamics.ca/referencespeakerlarge.jpg

Each cable run has one terminal end at the amp and two at the speaker and each run consists of 4 cables (or wires), with 2 of the cables going to each speaker termination. For a complete stereo set of speaker cables this means four sets of shotgun bi-wire cables with a grand total of 16 runs of cable. I tried this once & it choked the soundstage. I asked a very knowledgeable cable designer/manufacturer about this & asked if that meant too much capacitance or inductance? He said could be either or both. Anybody care to comment?

OK, I'm done, and I prefer Sharp Cheddar W/Port Wine.

Sugar,

I don't have two runs of the same cable to compare with the jumpers. However, I have been double-bi-wiring for the last 6 years using AQ Argents/Midnights. After some powercable upgrades, my system sounds much better by letting the speaker run full range. I lose a little on the highs and lows, but I am achieving midrange magic, especially after adding the Goertz jumpers.

I posted my findings in another thread before. Another agon member semed kinda miffed that I didn't like the Argent/Midnight doublebiwiring. He said the AQ factory highly recommends this set up. Well, they were good. But now the Midnights stick out like a sore thumb.

Viggen, I have a pair of double run (biwire) pair of AQ Slate (not currently using). They worked very well. I am currently using a single bi-wire pair of Blue Circle BC92. Even though a single cable, the BC92 is 10 AWG per termination at the speaker end, so almost like a double pair of other brands.