alternate method of bi-wiring

Viggen, I have a pair of double run (biwire) pair of AQ Slate (not currently using). They worked very well. I am currently using a single bi-wire pair of Blue Circle BC92. Even though a single cable, the BC92 is 10 AWG per termination at the speaker end, so almost like a double pair of other brands.

Hey Sugar,

For me to use bi-wire is double jeaporady. What I mean is, when I was burning in my P3 VD powercord with my speakers bi-wired, my soundstage was way too wide where the center focus dissapeared. Also, the deficiencies of the Midnight when comparing to the Argent became much more apparent after using VD's powercord.

Thus, I removed the Midnight and ran my speakers full range, Coherency and timing improved as well as focus. Swapping for the Goertz jumper improved on these 3 factors even more.

I did discuss this with Rick at VD lastnight. He told me the P3 does have a stage widening effect when connected to transports.

I've ordered the Audition powercord, to be connected to the transport. Then I wouldn't have the double jeaporady soundstage effect, hopefully, and might go back to bi-wire. However, now that I am hearing the obvious deficiencies of the Midnight, I don't want to use it again.

All this being said, I am very happy with the sound I am getting using full range with the Goertz jumpers.

You can also affect the center focus with speaker placement, if the cables sound great otherwise. My speakers are slightly toe'd in.

Wow, I learned a lot about bi-wiring from this post. As Driver has pointed out, I am currently applying Single bi-wiring. What I was asking if I can do is called True bi-wiring, which seems to be superior. So, now I must ask, which is the route I should go. First, I have the Decware Integrated tube amp and ML SL-3's using Tara Labs Phase II in a Single bi-wire configuration and silver RCA interconnects.

Do I:

1) buy 2 identical sets of cables for True bi-wire.
2) buy a better single set of cables and purchase Goertz silver jumpers.
3) buy a better single set of cables and run a short length of cable to the second set of speaker terminals.

Which method is likely to give the best results for a given budget, say $500-$600 for used cables? Perhaps this should be a seperate post, but any suggestion on which cable to use?

thanks to all,
Paul

Paul, You can keep your current cables & just use one of the speaker sets of terminations-just tape off the other set so they don't short out on anything. Then you can buy another set of cables and have a true bi-wire set up. From this you can decide if you like this cable better for the high or low freqs. (or both) and then proceed with the next step that you've already outlined. Just an idea on how to go about it taking small steps.

Given your budget I'd like to suggest Luminous Audio Renaissance speaker cable. You can email Tim & ask about your particular application. If youre interested & can't find the link email me & I'll forward it. Good luck.