Teres update

OK just a quick update. I need to drill the sensor hole, then veneer the plinth. I loaded the arm board with shot today. Looks real good with cocobolo plugs in ebony! I also shaved it a little thinner, just to be on the safe side. Every fit together nicely. I left the plinth about 5/16 bigger than the plans all the way around. I decided to put a couple of ebony dot inlays under the sensor ring on the plinth. Now you have to look for the sensor. Hoping to get final sanding done tomorrow. I took a couple of pics but left my camera at the shop. I'll try and get them up tomorrow.

Joe

Getting there. I was going to have a vinyl party on Sunday. Then today I decided to re-do the venner. Just wasn't quite there, IMHO. I came up with a better design. So, a couple of more days. Everything else looks spectacular. Arm board, done. Sub base, done.

Anyone close to Eastern North CArolina is welcome to come on over for the unveiling. Should be next weekend, 23-25 Jan.

OK. I am going to post a few pictures here in a few minutes. Here's where I'm at. The base is done. The armboard is done. The plinth is all veneered, and just needs the final scraping and sanding before the finish is put on. I went with amber shellac on everything. Then, after I steel wooled it out, I rubbed it down with parrafin oil with a little bit of pumice in it. I hope the pics will show the depth of finish on the arm board and base.

I'm starting to get real exited. Everything should be set up this week, and I'm going to have a bring your favorte album party next Saturday. Y'all 're invited!

Here is a link to the photo page directly. I am in the process of redoing the index page:

New Pictures

And for those who are really observant, I know the VTA collar is not sittting flush. I forgot to clean the crap out of the hole before I put it in for pictures (sounds like a bad porno movie).

Hi all, I had bad html that I just fixed. You should be able to see the pics now.

Joe

http://www.jphii.com