2. analog
  3. 1074189840

Setting up Analog In a New Room From Scratch

I am fixing to move to a different house in about a month. Where I am now, I have been restricted about where I could set up my system and I am doing the old everything on a rack between and behind the speakers setup. In the new place, I get my own room to do what I want and it is 20 X 16. I plan to use one of the long walls for the speakers.

I want to set up my turntable in the best spot possible, but not in another room like some do. Getting up at all is enough sacrifice for me, I am not trudging back and forth between rooms. Now, I get a bit of rumble if I turn the gain up too high, too quickly and figure that slightly bad bass response results from room interaction. Where is the best spot for the table? On a side wall? If so, at mid-point? Some point of minimum reflection? Back wall? That would seem worse than behind and between the speakers. Something tells me that corners are out, too. I have a wall mount for my table that is about 42 inches high.

Also, I have 10' speaker cables that cost me more than I want to admit. If I locate the table (and other components) somewhere farther than 10' from the speakers, am I better off to adjust by:

1) Locating just the table in the best spot and then running longer phono cables to my phono stage, located with all other components (but not between the speakers)?

2) Locating just the table and phono stage in the best spot (to minimize phono cable length) and then running a longer IC from phono stage to preamp where the preamp is placed near the amp and so that the preamp to amp IC remains at 1m and the 10' speaker cable length is sufficient to reach the amp?

3) Locating everything in the same proximity to each other and getting longer speaker cables?

4) Some other option?

Thanks
motdathird
uppermidfi
277 posts
 
Have you considered putting the amp between the speakers and having the whole front end out near where the listening chair is located? That seems to be one of the more popular means of setting things up since it keeps the amp from messing with the other electronics.
motdathird OP
77 posts
 
Uppermidfi, I did consider that possibility but it would entail, in that case, a long run of IC between the preamp and amp. Is this more advisable than other schemes I've mentioned? Maybe this whole thing is just a question of whether it is better to have longer IC's or longer speaker cables and, if the answer is IC's, which IC to make longer(if that makes any sense).

I would also like to know if anyone has good experience with the turntable placed in a specific room loaction relative to the speakers.
johnnantais
621 posts
 
There is one easy fix for wall mounts, assuming you can mount the wall-mount close to your equipment. I used to own a Rega Planar 3 which I sited on a wall-mount with the same problem you have now. What was happening was that the shelf that came with the wall-mount was vibrating - not the 'table - when the music was loud enough, and causing the rumble from my turntable. So I went to an acrylic shop and had a shelf made from a slab of acrylic, which I glued to the shelf with two-way tape. End of problem. Of course, all the other options of moving your table around would also work. A slab of marble also worked in the same situation, and at one point I had a three-layer sandwich of acrylic, marble, and the original shelf. But with each layer, the music improved. Cheap, and no longer cables needed.
More to discover