Cable run in burn in time

On the Audiodharma, the load resistance is far lower than it should be for interconnects. This can cause a far higher level of current to pass through them than they would ever see in any given audio based circuit. If the sonics are being "damaged" by the Audiodharma, that would be my guess as to why it is taking place. As such, changing the load resistance should not be a big deal and would correct the problem for future use. I don't know if Alan has corrected this in the current production models, but if he hasn't, he needs to.

As i've said before, not all cable cookers are created equal. My personal thoughts were that the Duo-Tech was a piece of scrap. Maybe there are more "pieces of scrap" burners than there are good ones. Sean
>

I'd tend to agree. As cable burn-in as about settling the dielectrics to their eventual extinction state (if you will), using an electronic device that may indeed damage them by overheating the active conductors is not a good idea. I'm fortunate that the dielectrics in my DIY PC Kits are simply Teflons, for which I successfully use a non-electrical burn-in processing. For fluorocarbons I had discovered back in the late 70s that the molding, tooling and extruding manufacturing process would result in a finished product state that still had mechanical stress potentials that would resolve ("cure") only over a VERY long period of time (months to at least one year). As the products manufactured were high-performance volumetric-measurement handtools (Pipetman, et al), it was mighty important to stabilize their structures before calibration so that they'd stay stable for their intended multi-year lives. My thinking is that since this same stabilization process (I'm calling it Enhanced Stabilization Technique for lack of a more inventive term) very measurably "settles" fluorocarbon products dimensionally, then there's quite apt to be an auditory correlate, since our ear-brains are far more sensitive than our labs' micrometers. So my take is that a "burn-in" process should get you where you're going eventually, and NOT provide an errant detour via an accidental over-processing, perhaps even ruining the performance of the product, as mentioned above. Users claim that my lowly $39 DIY PCs sound great right out of the box, and I suspect simply will change only VERY slightly with mechanical settling in over time...WITHOUT electro/mechanical machinatiing. Too bad this EST doesn't work on most cheaper dielectrics. Sigh....

Beware of over cooking your cables, I think that after you have approx. 200 hours on your cables they are 90% broke in and that last bit will come in time. I also notice when cables are disconnected the sound is some what thin or less dynamic and takes around 24 hours to settle back in! I notice this with PC more than IC.
I also notice that if you clean connectors every time there disconnected the resettling in takes less time!
This has been my findings in my system.
Happy Listening!

A rebuttal from the man who makes the cable cooker as posted on the Cable Asylum:

http://www.audioasylum.com/audio/cables/messages/75312.html