2. analog
  3. 1098500852

ClearAudio Reference w/SME V Vs SME10 ?

I am considering two tables:

1) ClearAudio Reference acrylic table (boomerang plinth) with an SME V tonearm.
2) All SME 10 table (maybe upgrade to an SME V tonearm, maybe not).

I will be using either with a ClearAudio Virtuoso Wood cartridge connected to a Hovland HP100's MM phono-stage.

Both pass the wife's aesthetic requirements so it's down to sound and performance.

Any opinions?

I have noted that VERY few Clearaudio Reference's or even Revolution's have been mentioned in light of the new Master Solution and Maximum Solution (too expensive). But my wife liked the boomerang plinth better then the tri-legged plinth looks wise.

Thanks,

-Matt
symphonicaudio
symphonicaudio OP
2 posts
 
That's one of my biggest issues!

I have a custom made Mahogany and Steel rack that weighs in at about 350 lbs and the top double wide plinth of mahogany is 3" thick by 24" deep by 40" long and sits on 6 industrial strength points in cups on the top of the lower portion of the rack.

I have been specifically informed that NO additinal platforms, vibration isolation or anything (granite, concrete, graphite, etc) can be used.

Will the mega heavy and solid rack be enoug to isolate either table?

I have say that my wife is leaning towards the Clearaudio Reference table but would "accept" either.

-Matt
jphii
485 posts
 
Your rack should do fine. If that rack cannot isolate any table, it probably can't be done.

I agree with your wife, get the Clearaudio. Just because Raul is clueless.
the_smokester
174 posts
 
I agree...Your rack sounds like it will accommodate either turntable.

Listen carefully to each one, preferrably in your own system for a few days, and buy the one that suites your priorities.
More to discover