2. cables
  3. 1070945485

Where to put the better cable.

Here's the scenario: CD > Preamp > Amp - that's two pairs of interconnects required. One pair is much better quality than the other, so where should the better quality cables go? CD > Preamp or Preamp > Amp ? I'm talking in general here. Of course the best thing to do would be to try it both ways and listen, but there must be a rule of thumb about this.

RLW
phydeaux
sonic_genius
528 posts
 
Cables react differently to each component due to output and load impedances. Just try at each component to get the best results.
jafox
1,452 posts
 
S23Chang: The particular belden cable I have indeed has separate signals for each phase. Whether or not it was "designed" to run this way I don't know...but it has 3 distinct lines and thus allowed the LS5 to run in its truly balanced topology. And it worked mighty well from the truly balanced PH2phono stage to the LS5 line stage.

The belden cable aside, I have owned cables as indicated previously as well as tried others such as the AQ Diamond which literally robbed the system's 3D presentation and ambience when used between the LS5 and VT130 ... but it worked quite well between PH2 and LS5.

The Cardas Golden Cross was an excellent value cable between the LS5-VT130. Its warm emphasis in the mids captured the LS5's magic. The SilverAudio Appassionata in this link brought on somewhat of an analytical sound but captured more low-level resolution than the CGC from PH2-LS5. Which one is better? "Better" is not the issue here. Each cable clearly had a synergy within certain links in the system. But the LS5-VT130 link was always the "make or break" in the chain when it came to getting that magical sense. And today I fine the same is true from my BAT31SE to Counterpoint NPS400.

So it is not an issue of the Belden but rather due to interractions which I am not qualified to desribe...all I can tell you is what I observed sonically.
subaruguru
1,374 posts
 
Timo, S23. Since impedence-matching requirements are probably quite different between the two sets of component interfaces, and the LCR values of the two cables are probably different, it DOES matter where each goes. It is rarely a case the weak link being a constant independent of position....
More to discover