Speaker Wires on Carpet


I was reading that carpet will interfere with the signal going through speaker wires if the wires are on the carpet. I was wondering if the amount of interference varies depending on whether the positive and negative wires are twisted together versus running straight and parallel to each other. Also, will certain types of wire jackets cut down on interfence?

I ask this because I have wires running next to the base boards on the floor in my (carpeted) dining room since that's the most unobtrusive place for them. I may consider some type of wire elevators if they are reasonably priced and look nice.

Thanks in advance for any advice.
socprof
Ceramic isolators in electric fence dept. of farm supply are comparatively cheap and include a molded in lag bolt you can fasten into wood block and saw flush.Home Depot and Lowes may have them in electrical aisle.
Well I was skeptical of cable risers also! I was sent 8 green edge acrylic risers by a friend about a year ago to review. I had a bad tube in my pre-amp on the left channel which would hum. I was awaiting new tubes, but trying out the risers lowered the floor noise to the point that you couldn't hear the hum! When the Risers where removed the Hum was back. So that alone convinced me, as this is not one of the snake oil type tweaks for twits.

I today use about 14 of these risers, through-out my system, also under powercords & lengthy ic's.

Frank at Signal Cable is now selling this riser at a very affordable price. They are more attractive than any of the other types on the market as at a 7-8 foot distance your cables seem to be levitating in mid air.

Try some styrofoam, or ceramic coffee cups to come up with your own verdict prior to commiting. Good luck!
I had static problems in Colorado in the winter with my carpet there. I saw a tweak suggestion of spraying anti-static spray on the interconnects/speaker cables and it made a noise reduction in my system.

I bought the cable isolators but never did a before/after comparison, I just wanted them off the ground.
For those intending to do before and after testing, be aware that, with some cables, the simple act of moving the cables requires some further break-in time before the cables are again performing optimally. This is clearly apparent to me me with the Goertz AG-3 speakers cables, but not as much so with the Omega Mikro Planar speaker cables. With the Goertz, the re-settling time was only 2-3 hours or so, but it was very audible. Just be cautious of this in judging the outcome of your experiments.
The easiest and least exspensive way to find out if you need elevaters is to go to your dollar store and buy some anti-static spray.Spray the carpet where the cables will rest and see if you can hear a difference.If you hear a positive diffence either get some non conductive risers or more spray for $1.