Impendance - Resistance & the story of "Z"


Can someone please help a non-engineer understand the difference between the two with regard to cable deisgn. (Aren't they the same? Is it me or is the use of both terms somewhat confusing?)

Reading a certain manufactures literature, it states that lower "Z" in a cable is always better. Is this really true and can someone explain why? They have an interesting graph showing their cable with a "Z" below 1.0 and all other cables tested with "Z" above 1.0

Just looking to understand. Thanks.
joperfi
Joperfi,

Impedance is a complex number - that is "complex" in the
mathematical sense - it has two components. The "real"
component is the resistance. The imaginary component -
which is the coefficient of "i" where "i" is the square
root of -1 [ yes I know they tell you in school that you
can't take the square root of a negative number - but the
concept exists in higher mathematics] and will be the amount
of capacitance, inductance, or "reactance" as Sean explained.

Think of impedance like a sailor thinks of his position -
there's both longitude and lattitude. Now lattitude will
tell him some things - like whether he's in the tropics
or a temperate region - but longitude is important too.
A very simplified definition, though not technically correct, would be:

Resistance: opposition to current that is constant no matter what the frequency (60 hz, 2kHz, 1MHz, etc.)

Impedance: opposition to current that varies as frequency varies.

A resistor gives a constant resistance at all frequencies.
A capacitor gives more "resistance" as freqency decreases.
An inductor gives more "resistance" as frequency increases.

The audio signal has a varying frequency, from around 10Hz to well over 20kHz. So it becomes an issue with cable designs to account for this in order to minimize the effect of cable resistance. For speaker cables, a lower overall impedance improves the amplifers' damping factor which minimizes the distortion by spurious signal oscillation from speaker-to-amp-to-speaker. As far as interconnects go, Sean covers it very well.
Gs: Your comments about resistance being frequency independent and impedance acting the opposite i.e. changing as frequency is altered was a very good point and easy to understand in the manner presented. I had worked that into my original post, but when trimming things down, it got lost in the shuffle. Kudo's to you for highlighting this basic but very important aspect of understanding electronics.

This is why testing amplifiers into dummy loads ( resistive loads that remain constant with frequency ) isn't a very accurate representation of how amplifiers actually "load up" into various speakers. That's because speakers are complex impedances where reactance varies with frequency. In some cases, reactance and therefore the impedance can even change as the drive levels are altered. At 1 watt at 100 Hz or 10 KHz, the amp might see what appears to be an 8 ohm load. Increase the drive level to 10 watts at that same frequency and the amp may see what appears to be a very different impedance.

Trying to achieve a smooth or "flat" impedance curve* is something that many manufacturers attempt to do by adding parts to the crossover network, but in the real world, those parts only add more clutter between the amp and speaker. In most of the speakers that i've heard where the designers placed great importance on this aspect of design and performance, the end result was that it tended to "suck the life" out of the music. There is something to be said for designs using minimal or no crossover at all. Sean
>

* a "flat" curve sounds kind of contradictory, doesn't it??? : )
the story of Z sound great and is very interesting and if this is true that the smaller the Z number the better then i hope that Jopherfi or someone can tell what co. this is so i can look into getting some of these cables to listen to. thank you .