Double up on Kimber Kable 4TC??


My old setup required extra-long runs of speaker cable (Kimber 4TC). My new setup allows for much shorter runs between electronics and speakers, so I cut the long runs in half. Can I use two sets of this cable on top and bottom?
Actually, I'm already doing it (4 cables per speaker: biwired with two pair on each set of binding posts). Although the sound is, IMHO, great, I was wondering if utilizing this method is a mistake due to some specific reasons that only you truly informed audiophiles would know about!

Your advice.

Thanks.
2chnlben
2chnlben,

I did get a chance to do some experiments. First, I doubled up my 4tc and kept the + and - cable five inches apart. It was a major improvement over a single run, better bass and no bad side effects. After several weeks, I felt that perhaps there was a bit of whiteness ( I cannot describe it better) in the upper frequencies so I put the + and - length together in a loose spiral. This further improved the base and the whiteness disappeared but perhaps there was tiny amount of less detail in upper frequencies. Now, this second arrangment is not the same as yours, but I suspect they are close. So based on my experience I would say that you should keep your arrangment. You should try to separate your runs only if you think that your base is too heavy. I should also say there was a big change going from 1 4tc to 2, but only a very minor change going from seperated runs to the spiral. One last note my system is bit light on bass so I cannot say which of the two arrangments are more neutral
Thanks for your input behnegan@bc.edu. I too feel that I am getting good performance by doubling up on 4tc. I definitely like the sound better than single runs of 4tc.
Now I'm looking for some good interconnects ($300/less/1-meter pair/RCA). Any thoughts?

Thanks
So what is the correct way to "double up" a cable for biwiring? Do you run both positives down one run of 4tc and the both negatives down a second run of 4tc, or do you run positive & negative for the woofer down one run of 4tc, and positive & negative down for the tweeter down the second run of 4tc?

Todster,

The latter is the right way to biwire, because the main reason to biwire is to separate the highs and lows. I should not that I was not biwiring. I was simply doubling up 4tc to increase the aggregate gage of my wire.

2chnlben,

I am happy with my homegrown audio silver lace, but if I were to buy a new interconnect today I would try something with Eichman plugs. I have not tried them, but their principle makes sense. There was also a recent discussion in Audioasylum for an interconnect without connectors, which seemed very interesting. The idea was to attach the negative wire with an 0 ring.
behnegan,
I recently heard that the Homegrown Audio Silver Lace is excellent. My system tends to be on the bright side, I wonder what that IC would do, since it is silver??

Todster,

Each "single" run of Kimber 4tc is actually one pair, with the positive and negative braided together. To double up, take two single runs (2 pair) and twist the all of the positive ends together and all of the negative ends together, then connect to the top; do the same for the bottom. You'll actually have four single runs (4 pair) in total, for each speaker.