phono preamps with a subsonic filter?

Dopogue, Apparently my response was ambiguous.

FWIW, my reference to a "bandaid" was to using a subsonic filter to mask a problem in the cartridge/arm matchup. The effect of mis-match will creep up into the audible frequencies if you don't correct the problem - by using a subsonic filter you just stop the woofers obvious flapping.

As to using a subsonic filter to solve software encoded information problems, do what works for you. I was just pointing out that mine did not work for me with the problem the original poster was referring to.

But here's a thought - if you can actually hear it in playback its probably not really subsonic, so a filter meant to really apply to the subsonic frequencies might not extend high enuf to affect audible frequencies. Perhaps my filter was truly a subsonic filter which rolled off before it got to the 20hz zone. Don't have the stats on the filter so I really don't know. Just a thought mind you......

Distortions caused by subsonics are audible. Though the filter can cause some vailing it is still preferable to the distortion and speaker/amplifier demands caused by subsonics. If it is important to you to be able to deactivate the filter for good recordings it may be worth while to get one that uses a switch rather than jumpers to activate the filter. However I would prefer to have a phono-pre that does everything well (Project Phono Box SE or Tube Box) than one the just has the capability to switch quickly. Even with the subsonic filter implemented on one of these phono-pres you are likely to see an improvement over anything cheaper that offers subsonic filter.

Good luck!

Hey everybody, thanks for your responses. I'd prefer a tubed phono pre, so I may look at the Pro-Ject model or the Quicksilver. Thanks again, Jeff.