Subwoofer Cables. How important is quality?

ill toss in my response here...

i think sub cables make a huge difference. if you would have asked me 6 months ago however, i would have told you that get a good shielded cable and its fine...

i run dual velodyne HGS15x's in my system. i had some decent RG6 silver cable by audioqest for a sub cable. it was pretty good stuff. i recently upgraded to synergistic research resolution reference sub cable. the difference was pretty huge. it sounded like a total upgrade in subs. one of the active shieldings got severed and i had to get it replaced. when i sent it in, i just used one of my old cables to power that one sub. it was SO much worse (after living with it for a month or two), i just turned off that sub all together and just used a single sub. it just didnt sound good at all without that cable anymore.

granted, these cables are $1k for a single 3m cable, but there are more reasonable cables out there. just borrow some from a dealer and test them out. try the new line of audioquest, or depending on your system and budget, look at the synergistic research ones. the res ref is HIGHLY recommended if you can justify it for your system.

With regard to subwoofer cables - interconnect and power cord - I have some pretty enlightening experince.

Several years ago, I tried comparing a Synergistic Research AC Master Coupler (a shielded twin coax design) and a DIY power cord based on Kimber 8TC (a braided speaker cable) on my Mirage Substrata 1500 (a design very similar to the original Sunfire subwoofer). As my system integrates 2-ch and hometheater applications, I can listen to stereo playback without using the sub. To my amazement, the differences between the power cords can be heard without using the sub! With the SR cord, the sound is significantly cleaner and more detailed. My theory is it's due to the shielded nature of SR cord, which reduced the electromagnetic interference (EMI) produced by the sub's switching power supply from radiating through the power cord.

Fast forward to several months ago as I was preparing to replace the Mirage sub with a Velodyne DD-12. Since I plan to move the new sub closer to the rear wall, I decided to replace the sub-end connector (Eichmann Silver Bullet) of my subwoofer cable (XLO Pro 100) with a 90-degree Cardas GRNO. The "downgrade" was so awful that I changed it back the next day. The Cardas GRNO change alone made the sound - full range sound - slow and fuzzy.

The last episode took place this week as I replaced the SR AC Master Coupler (now called the AC Master Coupler Classic) with a SR Active AC Master Coupler (the X version, not the latest X2 variant) with Active Shielding technology. This time the most staggering improvement was in my humble analog cable TV picture! Video noise was reduced and details were improved. I suspsect the improvement is due to better shielding (Active Shielding) in the new power cord.

Alan Hsu

Sorry to ruffle feathers but personal listening leads me to the conclusion that cables make very little difference. With most peoples systems that money is better spent on new equipment. Most people own mid-fi gear that can bennefit in small ways from better cables. A good read of Master Handbook of Acoustics can help tremendously with the understanding of in room frequency response (speaker placement).

Well-built cables that total to less than ten percent (mine are about five percent) of total system cost is a fair figure for cable cost.

-2 cents worth

I suppose if you are tone deaf, cables will make very little difference. I have had the opposite experience using various cables in low to high end systems over the past 35 years

.
Bignerd,
.
It is hard for you to comment on what you are not capable of hearing. Cables make a huge difference.
.