2. digital
  3. 1042691870

Running a cdplayer directy to an amp impedence q

I'm getting a CAL CL15 which outputs 0-3v at 50ohms.
What factors should i look at when considering an amplifier to mate directly with this cd player?
Is the voltage number the important one? or the impedence? or a combination? Am I looking for higher? lower?
I'm a bit bewildered here!
Considering:
BAT VK200, input imp = 100k, input v = 1.6v
Rogue 88, input imp = 200k, input v = 1.0v
and a few others....
geoffgarcia
zaikesman
3,017 posts
 
Herman - I would hope the digital output (S/PDIF) is 75 ohms to match the standard.
cjr888
34 posts
 
You should have absolutely no problems with an output impedance that low and with the listed voltages required to bring to full power.
bigtee
803 posts
 
One word of advice as a past owner of the CL15. While it will drive most if not all amps fine, the digital volume control has a tendency to limit dynamic range as you reduce the level. I found it to be much better going through a preamp and letting it control the volume.
I would suggest you check this out to see if you want to live with it. Of course, you can always add a preamp later.
More to discover