2. digital
  3. 1090068720

JoLida 100 potential problem


Hi there,

Yesterday I recieved my Rca tubes and I immdiately installed them. Easy enough to do enough though it's pretty cramped inside maybe it's due to my level-2 mod. On to my question when I installed the new tubes and put back the metal sheaths I tried to tighten the screws but was unable to do so. I left them unscrewed in this state can a problem what so ever occur. I'm mostly concerned when moving the player that the screws will pop out.

Thanks

freakygreek
ketchup
698 posts
 
You can do it :)

Disconnect the connectors on the circuit board, remove the screws, and lift it up enough to gain access to the nuts on the bottom of the board. A small wrench set will help hold the nuts when you tighten the screws.
freakygreek OP
95 posts
 
Ketchup,

You the man your advice worked like a charm I was able to tighten 3 out 4 screws. The last one came undone completely red washer and all. I tried but it is nearly impossible to do the last one by myself. Turned it on and it plays beautifully.

Thanks again for the encouragement if it wasn't 1:00am I'd celebrate.

Cheers
usblues
1,217 posts
 
Occasionally it helps to locktite[blue] or silicone the nuts so they dont move around as you fiddle.....good luck,Bob
More to discover