TEACH ME ABOUT BI-WIRE

i was under the impression that biwiring, in some cases, can be effective because the back-voltage going thru the wiring of the woofer is now separated from the wiring to the the tweeter, even tho it eventually meets up back at the amplifier. i believe that having the connection point several feet of wire away, at the amp, instead of at the speaker, can make a difference. i know my monitors sound better w/a stereo amp when bi-wired, as opposed to having a single run w/the speaker mfr's factory yumpers in place. but, perhaps its sonic degradation of the yumpers? or yust the fact that, when bi-wiring, i am doubling the quantity of copper cabling? i admit that i havent tried doubling the speaker-wire to only *one* set of terminals w/the yumpers in place...

doug s.

Liguy is right, it makes a big difference with Martin Logan speakers. The first set of Aerius i I tried out where set up for single wire only, I ordered Bi-wire option just in case it would benefit ( only 100.00 or so ) The new set came, I broke them in then bi-wired. Big change.

I disagree with almost everything Jostler, Stevemj have posted here, and so do the majority of high end speaker manufacturers, but they are entitled to their opinions.

The actual mechanics of bi-wiring, and special design of seperate crossovers that control what signal travels down each cable are covered in detail on many differnt web sites.

The only question to the customer is do the benefits of bi-wiring overcome the additional cost involved with two sets of cable. Or another way of putting it is do two sets of $500 cable sound better than one set of $1000 cable.

Hey Sedond, try leaving the jumpers in place (be very careful not to cross plus and minus), or as Jon Risch suggested in another forum, just the jumper for the "negative" side. First, if the sound is the same with both jumpers in, I would assume biwiring has no effect other than more wire. Second if the sound is better with one jumper left in, then you have a cheap tweak upgrade. Might be worse though, people have reported different results.

paulwp, if i unnerstand ya correctly, i should try the yumpers *and* biwiring at the same time? and, yust yumper the negative while biwiring? as i'm currently using only one amp, - i traded my electrocompaniet aw100 for an aw75 to match my existing aw75, & it's not here yet - i can try this...

doug s.