Custom jumpers?

Analysis Plus makes good jumpers with bananas that are easy to use with spaded speaker wire. Oliver has them at delveaudio@aol.com. I have three pair in different systems and instantly noticed the improvement.

Allways use a piece of you speaker wire.Use the same cable so it does not change the sonic signiture of the cable.

IMO: Dekay, Hrcapers, Khaki8, and Leafs each gave correct information. I have tried them and you should too. Select the method that sounds best on your system :-) !

I would give DIY jumpers a try. If you can use the same speaker wire as your long runs try that first.

It has been my experience that custom wire will always perform better. Another tip would be to play around with your speaker wire connections, that is, jumper down or jumper up. I was told by a speaker manufacturer to try jumper down (connect speaker wire to the mid/high connector with the jumper supplying to the bass driver). With my small Aerial that I had at the time, jumper down was better than jumper up. Try it!