2. speakers
  3. 1000416737

Homemade floor protectors -- advice needed

Here's my situation: I have hardwood floors that I want to protect from my speakers' spikes. I could use those little support disks, but they're a pain when adjusting the speaker position (they move out of position, and then I poke holes in the floor). Instead, I was thinking of placing two stone "tablets" on the floor, and then putting the speakers on top of them. There's a shop nearby that will cut the stone to my specs, and then polish the sharp edges.

My question is, what kind of stone would work best? Granite, marble, or something else? And would some small rubber "feet" on the floor-side of the stone still allow the tablet to couple with the floor to reduce resonances further?

Any insights you can share would help!
stevenb
mezmo
516 posts
 
Best use of those AOL CDs I've heard yet. Bravo. I've been using pennies and, believe it or not, one the spikes went straight through one after about a year. Think it would be cost-effective to upgrade to nickles?
bob_bundus
1,834 posts
 
Mez thanks for the laugh... Sounds like a cost-effective upgrade although we're talking 3cents to 15cents: a 500% cost increase. Interesting that the spike would drill right through a penny. Aren't all coins a copper sandwich now? The weight alone may not be the only factor, but adding long-term vibration must be enough to do the job. It would only take somewhat longer to drill through a nickel if that's the mechanism.
mitch2
4,079 posts
 
I use cone coasters by sound anchor (the people who make speaker stands). These disks have a "dimple" in the middle for the point of the spike to set in, and a kevlar/polyester "sandwich" on the bottom, which is easy to slide around. Look them up in Stereophile's recommended components. I have no problem repositioning my 4-spike Alon V's, which weigh upwards of 100 lbs each, by sliding them on the cone coasters. Otherwise, for the best sounding alternative, you can always bolt them to the floor.
hdm
1,062 posts
 
Forget the spikes and buy some vibrapods; buy 4 for each speaker not 3 at the proper weight. I used to spike my speakers through carpet to a hardwood floor, but after some experimentation, settled on vibrapods on laminated glass on top of a low pile carpet that I have. If you're a real detail freak, this may not appeal to you, but if you're more into musicality, I'd definitely give the vibrapods a try.
stevenb OP
1 posts
 
Thanks to all who posted - you've given me a lot to think about. I suppose I can simply spike into my (rented) hardwood floors, then invest in some wood putty to cover the holes when I move...certainly a lot cheaper than *buying* a place in SF ;-)

One thing to note: the "Audio Selection" support cones and disks that AA sells are very nice, but the disks have adhesive tape on the bottom, to hold them in place, for example, on a shelf. I didn't remove the plastic film covering the adhesive, but after sliding the disks around over a few months, the film peeled off...sticking the support disks to my floors. Next time I'll try disks w/o any tape.
More to discover