Please help tube amp for panels and SS for woofer

Jonathan, seriously please. Is there any reason why I should choose different cables than the HMS Grand Finale with the Wolcott? Has it to do with the specs of the new Wolcott?
I am open to any suggestions, since the reason that I sell HMS and believe that these are great cables, does not mean that I will not listen to suggestions of other people.
So please tell me what you know about these Wolcott amps and what cables you would suggest and why you would recommend these cables.

Tekunda, Jonathan is pulling your leg on the cable issue but is sincerely recommending the Wolcotts.

if your preamp has 2 outputs and you still want to try bi-amping you actually only need to attenuate one side of the bi-amping (you would need to experiment to discover which side). you could use the Placette RVC (remote volume control) on the stronger side to attenuate it to the correct level. there is a possibility that this might not work but it is a much simpler solution and more transparent than other crossover solutions would be (and with those great HMS cables why lose any transparency).

you would need to try to keep the total interconnect and speaker cable lengths the same to avoid small timeing errors but you are a "cable guy"....right.

Mikelavigne, I assumed that Jtinn was pulling my leg, but nevertheless I asked Mr. Strassner if cables in general can cause an issue with tube amps. He is a real scientist and gave me a 1 hour lecture in cables physics. What he said was that I might run into problems with a zero feedback amp, if the capacity of cables in general would be above a certain number. So unintenionally Jtinn made a valid point, but since the Wolcott amp is not a zero feedback design, it does not apply to me.
So yes, I am very happy to be able to keep on using the HMS cables in my new system.
I will check into the Placette RVC and for someone fighting with the same problems here is another link I have received: http://www.tweakaudio.com/Ultimate%20Attenuators.html
But I think I will stay away from an active crossover. I emailed the www.electrostaticdoc.com and he said it is rather complicated and frustrating to get it right with ML speakers.

Tekunda, Yes I was only kidding about the cables with the Wolcott's. It was all in fun.

On the other hand, I urge you to try the Wolcott's without bi-amping. They will surprise you.

Make sure you get the high bandwidth version of the 220 Presence.

Tekunda, I would head the advice of others and try the Wolcotts by themselves. Unless you use an active x-over, the biamped Prodigies will not sound good with tubes on top and SS on the bottom. In theory, the combo should work. In reality, however, the internal Prodigy x-over will contribute to a muddy midrange since the amps will blend in this region. Without using an active x-over or two identical amps, biamping usually messes up the speaker's midrange. I have sold Prodigys before and usually suggested a solid state big amp. I love tubes, but must admit that big tube amps such as the Cary 211s worked ok, but sounded slow compared to the speakers driven by Krell amps. The more current these speakers get, the more they come to life. Although more sensitive than past designs, the Prodigies still dip down to low impedences that tube amps do not like. You never know, though, until you try. See if you can track down the x-over Martin Logan used to sell with the Monolith. Better yet, give Dave a call at Martin Logan and see what he thinks. Good luck, Patrick