Woofer damage from new Star Wars THX DVD?

Hmmm....
A 36 dB increase from what level? There's gotta be a reference point somewhere, right? And the frequency(ies) of attenuation might be better info to provide also.

But quick advice would be to check the disc vs. another. I'm sure SOMEBODY else besides you bought it. Distortion, rather than dB level might also be the problem. Whether produced by source, software, or amplifier (gain stages, yep!), the distortion is much harder for the amplifier to control than a clean over-emphasized recording.

Threatening the speaker manufacturer with negative newsgroup postings might get you some sympathy. Or maybe organizing a petition if enough people have actually had damage occur, you could contact the disc manufacturer. Keep accurate records either way. I'm curious.
As with most software, I would assume that the manufacturer only warantees the product, NOT the aftermath. Or connected components.

Back to the 36 dB issue.... WHERE did you hear this?

And lastly, if the SPL was enough for you to consider hearing damage..... Maybe you have a class action lawsuit on your hands. George Lucas probably has some mighty deep pockets. Of course, he might counter-sue because your Utopias aren't THX-Ultra II rated. Nor was the amp or the cables.

Tsrart, your theories are largely incorrect for your reference. It really doesn't work that way. What happens is largely that drivers(usually the tweeters first) get blown from being UNDERPOWERED when asked to handle more demanding levels! The amp cannot supply the current to properly control the driver(s), and therefore "clips", causing the drivers to distort, to simplify.!
It's a common misconception amoung new audio enthusiests, to think that too much power is the cause of breaking speaker components. It's not the case largely.
Also, a speaker will only respond to the signal and current that it's being fed. If you have more expensive/higher out-put potential gear, the gear isn't going to "try harder" or drive harder per se, simply because they have more potential.
It's not like a race car engine that's "more tightly wound" or anything. We're just talking about passive components that are sometimes overpushed from what they can comfortable handle. Or they are underdriven from the volume they're being asked to handle. Talking about speakers of course.

Thanks for your comments, Sean; always helpful.

I went back and played the DVD again last night on my Mezzo Utopias (powered by a Belles 350A) and on my Paradigm 100s (Parasound 1500A) with and without VMPS sub (Crown K2). I played them both hellishly loud (paintings on the walls went crooked and stuff in the china cabinet rattled and danced around) and none of the woofers even bottomed, let alone blew.

Something pathological has to be going on with Avimar's system.

will

I did the same thing Will. I could not understand how that could damage ANY system, even at massive volume. I turned my pre / pro up seven notches higher than normal ( and i like it LOUD ) and nothing even flinched. There just isn't that much bass during the opening THX "electrified exploding sphere" sequence. Something is really wrong somewhere. To blow up a driver ( let alone two ) with that big of a motor structure would really take a lot of brute force over an extended period of time. Either the drivers themselves should have never been shipped out the door ( defective ) or the amp has got BIG, BIG problems. Sean
>

Sean... is it possible for the drivers to blow
if they are sent a signal that is simply below their
achievable level? So this could be a problem caused
by a PRE/PRO capable of sending a signal below 20hz
and the speakers not being capable. I know in some
of the newer PRE/PROS you have an option of declaring
a sub as either THX or non-THX. And if you do declare
your SUB or MAINS as being THX a lower signal will be
passed. I remember reading about this problem somewhere
a while back...

I also played THX intro on mine and think unless he had
the volume UP WAY TO HIGH this shoulent have happened.