Do you own Dunlavy SC-IV's AND a yardstick ???

Sean, I am not sure how you arrived with the 43" figure. From conversion...1" to 2.54cm, the tweeter height should be 37.5".

16cm = 6.3"
50cm = 19.7"

Let me know if I am wrong. Thanks

Yeah, my head was in the clouds for some reason. I was using the wrong conversion ratio when i did all of those equations. Good thing i didn't start sawing wood based upon my "dazed" calculations : )

Having said that, 37" seems a tad low to me for an average seated listening position. I have to wonder what the average height is for someone's ears while seated ??? Sean
>

Sean, I measured my Dunlavy SC-V’s.

I measured twice so I’m pretty sure that the accuracy is within ¼”

Mine are on the Dunlavy bases which are 2 ¼” thick.

From the top of the BASES (add 2 ¼”) to floor

Tweeter 38”

Mid 31 ¾”

Lower Mid 21 ¾”

Woofer 9 ¼”

The speaker array is symmetrical around the tweeter

I listen with my ear at tweeter level in a bean bag chair. I do not correct the tweeter response with my Sigtech as the slight roll-off above 10K gives me a better listening experience

I have access to MLSSA and other RTA’s including the one that is associated with my Sigtech. In my good sized and moderately treated room they require relatively little correction from the Sigtech and the impulse and frequency response is excellent.

I listen to a lot of live classical music and for orchestral music they are hard to beat.

Let us know how the project turns out.

Pls1, Dunlavy V's and Sigtech sounds (reads) impressive. May I ask if the Sigtech maintains phase coherence while "correcting"?

Yes. The correction is in the time domain. "Flat" frequency response is actually the "side effect" so to speak of maintaining the time coherence. If you Sigtech correct a non phase coherent speaker more of the processing power goes to correcting the speaker and not the room.

With the Dunlavy all the Sigtech processing goes to minimizing the room effects. With Dunlavy providing the actual frequency and impulse traces for each speaker you can see how close you can come with your in room measurements.

My approach was to first do the best I could in buying a house with a suitable room. (We looked at 500 houses) Then got the best room placement(first approximation with room software). Then basic room treatment(not so basic subfloor reinforcing). Then use the Sigtech correction.

The final result is I've pretty effectively eliminated my room and maintained impulse/phase coherence with flat frequency response from the high 20's to 10K. I could get them flat to 20K but as I said above I prefer the room roll off