Listening fatigue


This may be low-brow for Audiogon folks due to the nature of the gear, but here goes: I have a pair of Totem Mites driven by an NAD 326BEE, with an NAD 345BEE disc player and a Velodyne SPL-800 in my master bedroom (carpeted, basically about 15X20 with a small entry hall). The problem is fatigue – if the volume goes up, it gets to be too much very quickly. I've tried different speaker locations and padding on the first points of reflection, but it hasn't helped much. I'm using 12 gauge wire, but would an upgrade here help? Or is it an unfortunate component combo? Any suggestions would be appreciated ... thanks.
128x128jeddythree
I would say you are clipping your amp. Your amp is only rated at 50w into 4 ohms. Your speakers are 87db/m. So if seated 15 ft away that calculates to about 96db. This leaves nothing for dynamics which can EAT power. Like I said, if its mainly at higher SPL's I would bet your clipping the amp.
Agree that clipping is a likely significant factor with most any SS amp of that power rating and most better modern smaller speakers.
The sound travel 1000 feet per second. You can hear the sound from speakers for 4th of a second and the sound will travel 250 feet. Your room is 15 x 20. Every sounds from speakers will bounce walls and hit your ears more than 10 times. That's no good! I don’t know if your room is sonically live or dead. If it’s live, you need to tame your room. You need to reduce the sound reflection.

I recommend 1) Madisound Dampers: Felt Defraction Ring for Tweeters. Put these $2/each felt ring on tweeters of Mites. These dampers will reduce some early reflection sound from speaker cabinets. 2) If the room is live, put some Auralex or sound absorbers on walls. If possible put some damper on the ceiling too. If your wife think they are ugly, put some pretty curtains on walls instead. Good luck!