Magnepan MMG's just arrived

Congrats on the Maggies Dave43.I heard the MMGs at a friends house on a vector integrate 60 wpc also paired with a Adire active sub. Sounded damn goood!!!! I am using a Panny SA-XR25 on a pair of 2.5Rs. With very good results. Had to take the silver cable off thou..too much of a good thing with the ribbon tweeter. Plan to sell but have seriously considered keeping them. Hard to replace the sound of Maggies! Depending on the room your trying to fill it doesn't take a lot of power to get great results.

Happy Listening!!!!

Loontoon: Thank you for your entertaining,true post.

Dave43: If this has not happened yet,sooner or later,you will hear a sound seeming to eminate from the side or the back of your listening room. It is an example of artificial reverberation.http://ccrma-www.stanford.edu/~jos/waveguide/Schroeder_Allpass_Sections.html This "colorless" reverberation is created by maggie singing forwards and backwards at the same time. Sooner or later,you will get the distance from your rear wall correct. Paradoxically,the correct distance for the reverb MIGHT ring. If(when)it does,deaden the rear wall. Go to the wallpaper place and check the sample book for acoustic cloth wallpaper and paper the wall behind her.

When you get it right,the soundstage will have height,width,and depth. You'll be able to follow contrapuntal lines without the speakers getting in the way.

I use a medium power/high current,low feedback, solid state,integrated amp and believe that once you get the imaging correct,everything else will start to fall into line.

I agree with others' posts about upgrade itches but believe that getting the imaging (including the rear wall) correct is the most important thing.

ENJOY!!

Jafox...If you are still searching for an "affordable" high powered amp to suit Maggies, try the CarverPro ZR1600 digital amp. Don't laugh! For about $840 you can find what you are looking for.

At last, someone who has bought the MMGs! I have been waiting for a thread on them as getting Maggie's effect with a smaller, wall mounted speaker seems very enticing.

I have had good luck with an Anthem MCA-2 series 1 for a mere $400. Gives you 200 watts at 8ohms or of course more for the 4ohm maggies. I have had good luck with Rotel amps too, but the Anthem was better with the mmg's.

The FIRST thing you should do is take off the panel on the back and wire out the fuse with a soldering iron--you may want to wait until after the 60 days as it will void the return policy. The fuse is there to blow if the speaker is driven at high volumes for a long period of time to prevent the voice coil wire from getting too hot and melting though the milar film. I have had maggies for 8 years and never blew a REALLY enhances the imaging. I have removed the fuses on my MMG's, SMGa's, and MG-III's with no problems.

Also, crossover upgrades on the mmg's make a big difference. I replaced the caps with Multicaps for $18 each. Great improvement and easy. I also replaced the inductors with air core units. This was harder, but also valuable. My experience with replacing crossover components on my MG-III's suggests replacing the inductors should be done with the caps.

These are good suggestions for upgrades once you decide to keep them. I think the MMG's are an astonishingly good speaker for the money, particularly if you buy them used and spend the $175 on crossover upgrades.