Large Speakers Small Rooms


I've always thought about using large floorstanding speakers in a small room but never tried.How many of you have this combination and if so, how does it work out for you?
romakabi
be VERY careful with big speakers in a small room. I tried my big Coincident Total Victory's in a 10'x16' second bedroom- the bass overloaded the room with any decent volume level.
My main listening room is in the basement, 12'x17'x7.5'. I recently bought Vandersteen 3a signatures. Out of curiousity, after a few weeks I lugged them, my amp, pre, and source upstairs to my living room, which has a 25' foot cathedral ceiling and is around 20'x30', not counting the dining room which it opens onto. I tried to set them up the same distance from the back wall (41"), and kept the listening position the same distance from the speakers (about 10'). I couldn't duplicate the distance from the side walls, in effect in the larger room the closest one speaker was from a side wall was about 4'.

What I found was the larger room had the effect of expanding the soundstage significantly, both in width and height, which didn't surprise me. Bass response seemed to be better, but I couldn't be sure whether it was because I expected it to be better or it really was. What I did notice (which I didn't expect) was a "sharper" sound, as if "focus" or "definition" or whatever was better -- less sibilance on the cymbals, a bit more "cut" to vocals. My guess is that I was hearing fewer of the sidewall and ceiling reflections that I was used to in the basement room. I've gotta get treatments for that thing...

Hope this helps.
The simple answer is about what Newbee said. It's really more practical, in most applications, to use smaller speakers and maybe a well placed sub(Preferably EQ'd!).
Big speakers with deeper bass extension will tend to make it harder for you to get anything but bass heavy, thick, slow, boomy, "one-notey" bass, basically not smooth, flat and natrual. Small room already are heavily challenged acoustically, especially in the bass region! Putting large speakrs in there makes things tha tmuch more boomy, "unatural", "one-notey", and just plain "small room" "boom box sounding!".
Your only hope with even modest sized speakers in that room,complicated by the fact you're going to have to be near the back wall(depending on setup, but no much room either way) seat-wise, and your speaker are forced out in the room to try to smooth and even out your bass for natural sound and dynamic range.
One alternative here to making large speakers work in large rooms (like what is even comon with the small room setups at CES and other Hifi shows), is to use a good Parametric EQ on the speakers! Your basic choices are limited to either a good high end expensive parametric like Rives audio makes (see Stereophile, and or do research, even on this site), or use a basic Parametric on the bass drivers and bi-amp! This is an option on some speakers that sound good bi-amped (some don't!). IF you can EQ the bass on a speaker while leaving the other fundamentals (mid/trebble) intact, you can get some potentially stelar results with good set up and acoustical considerations in small rooms indeed! It's just a lot harder than it is for large rooms!
Still, for most, I'd recommend against large speakers in small rooms, unless you know what you're doing...most don't
If you can find a near mint pair of the old Snell Type A's you may do well with these. They are large full range designed to be placed against the wall. I've listened to them in a small room and they sounded good. I would do some room treatments regardless of the size speakers you use. In your small room cost will be low.

Dave
Avoid large speakers with rear or side firing woofers in a small room. In addition, look for a speaker that has adjustments (switches) to contour the sound. Pay special attention to the radiation pattern. You may have to use a parametric eq to get them to work.

That said- I am using Snell XA-90's to great effect in my basement listening room. 10 wide, 7 high, 22 deep.

I once had a pair of b+w matrix 802 that also worked well.