Von Schweikert VR-4,Jr.

Semi: Quite an intelligent reply to Rob, I agree with you, I will not purchase products made in China for both quality and political reasons, mostly political the truth be told.

And frankly, the folks at Von Schweikert can talk all they want about 'how much more their speakers would cost' had they been made in America, or 'the savings are being passed along to the consumer'. I don't believe consumers are gaining any financial benefit by Von Schweikert outsourcing their products to workers in a country that earn $1.00 an hour - probably less. If at all possible, I'll invest my money in products that are made in America.

Just my 2 cents - where others invest their money is their choice.

BTW: I own/use a Mac G-4 computer.

Best Regards

Funny how quickly a thread can digress. I hope we're all driving Fords and Chevys also.

I think all of your responses were very factual and mature (not always the case). I used to work at Cadence Design Systems - One of the top EDA software companies, so you are right about most of the chip designers and foundries not being in China. My point in making my general statement was that not buying Von Schweikert speakers will not make a bit of difference in toppling communism in China. Especially, since we are not all driving Fords and Chevys, and we all have electronic and other items made in China -- It’s unavoidable.

But how can I argue when your hearts are in the right place. That’s really what counts whether it makes much difference or not.

Have all of the VR4jr users biwired the speakers? If so, which cables were used? I have them powered by a McIntosh 2102 but not biwired, and there is some graininess. Thanks for your counsel!
AGA

I am expecting my pair in a few weeks. At least initially, I am not planning on bi-wiring. I'll have a single run o Kimber 8TC to each speaker and a pair of custom jumpers (made of 8TC) to replace the stamped metal plate jumpers they VSA supplies. Besides that I will use the supplied umbilical to connect the two sections of the speaker. I know biwiring is preferable, and bi-amping even more so. What are others doing?