Anyone using baffless speaker with a full range?

You probably mean open baffle (OB), not "baffle-less"? For a comprehensive intro to OB try S Linkwitz' site as well as Melhuish's. Generally speaking OB will sound very "airy" (a bit like a stator with dynamics). To make a long story shorter, the low end starts rolling off (@~6db/octave) at a frequency determined by the width of the baffle. You'll need a woofer/subwoofer (that can be OB, too -- preferably) and proper equalisation, preferably before the amp (passive or active).

Your amps can easily drive the upper range (say from 150-200Hz and up) in a multiamp configuration. You'll need a bigger amp for the low end

Quite a few people are using wide-range drivers in OB; for a simple implementation look up the supravox site, & check out discussions over at diyaudio.

Finally, Mr Olsher's "Basszilla" speaker is a Fostex OR Lowther OB design. I strongly recommend you look it up at Blackdahlia.

OB is well worth it!

Bemopti123, I have also been intrigued by the Phy drivers, though I never considered mounting them as you are interested in. Please let us know if you do try it!

Getting bass from that type of system is a challenge. Basically, if you widen the baffle enough to get good bass, you impair the "airy" reflection from the wall behind the speaker, which is why you go open-baffle to begin with.

So, you'll have to do experiments in your room to get the "happy compromise".

I'm sure that there are some aspects of the sound that will be very satisfying in OB configuration. If you can reach an overall compromise that satisfies your listening tastes, you have succeeded.

I'd suggest making a simple baffle board, mounting the drivers, and adding temporary extensions to the baffle board in increments, to see how big you'll need it for the sound you want to achieve. Then you can make some permanent baffles. Using a slightly rearward-curved baffle can reduce edge-diffaction effects which could affect imaging. I'd expect you'll need at least a 3' square baffle surface to achieve decent bass response. Baffle-step losses will begin to occur at the frequency corresponding the 1/4 wavelength of the smallest cross-sectional dimension of your baffle. Distance from the wall behind will be important also, as in any bipolar speaker. Cancellation can occur if not properly placed.