resonance and sealed enclosures

This has to do with port velocity and turbulence within and / or near the port entrance and exits. Using a port that has radiused flares tends to reduce these problems quite a bit. This allows the port to maintain more consistent tuning / proper operation over a wider spl range. If such a port is not used, the output of the port will be far peakier in a specific spl range and lower the performance standard if used outside of a narrow range of average spl's. Using a port that is flared on one side rather than at the inlet and the outlet is better than a straight port, but it will still run into the same problems, albeit to a lesser extent. Sean
>

Sean...We know how you feel about vented speakers, sealed speakers, and even TL, but what is your take on the resistive vent, such as used with great success in the old Dynaco speakers? I tried this once with a box that was a trifle too small for the driver, but didn't see much effect, good or bad.

El: I don't have a lot of personal experience with this type of design as compared to others that i've discussed, which for the record, is called an Aperiodic or "Vario-Vent" by some. From what i have heard, experienced and read about these designs, i like it better than most commercially available ported and passive radiator designs. Like anything else though, one would have to carefully select the proper box / driver combo to obtain optimum results.

As a side note, there was a commercial speaker designer that was posting on AA under the pseudonym of "Mr Bigglesworth". Whoever he was, he wanted to remain anonymous but at the same time, tried to share his experiences and educate the masses. When it came down to it, he stated that if one were do all of the measuring in the world and their goal was to achieve the highest levels of linearity possible, a sealed and stuffed low Q box would be what they would end up with. I asked him what his thoughts were on Aperiodic's and Transmission Lines and he referred me back to the sealed box along with an explanation why he had those thoughts. Given that i was already on the same page that he was, i didn't need much convincing. I was just looking to compare notes with someone inside the industry that didn't have a reputation to uphold or specific product to market. Sean
>

Sean, what do you think of Miller and Kreisel's push/pull design?

Push / Pull lowers distortion, increases power handling, faster transient response, lower impedance peak at resonance, improved power transfer characteristics, etc... If properly implimented, it can be quite beneficial. I'm using a dipolar push-pull arrangement for my own personal subs. The dipolar pattern reduces standing waves, which further improves the linearity of in-room response. Problem is, you've got to use twice as many drivers, resulting in a lower impedance, much higher cost to build and the need for a much sturdier amp. Sean
>