Egglestone Andra 1 tweeter "crossover"

Thank you for your prompt answer. It is correct, I am trying to lower a little the high frecuency response of the tweeters (I always hear classical and jazz music and sometimes I find them too bright for my taste). I am using VTL MB-250 amplifiers with Transparent Reference XL-V speaker cables to the Andras 1(I also have a Sony SCD-1, AU24 RCA interconects to the Blue Circle BC3 Galatea pre-amp and Transparent Reference XL RCA to the Amps too). I had used another pair of Au24 interconnects between the pre and the amp but the sound was too analytical and crystalline sharp...

Oh oh,sorry,didn't read your post carefully.

Vector, if that's your goal, I'd dig up 2 pots (potentiometers) of relatively low value (say, NMT 1000 Ohms) and wire one in series with the tweeter BEFORE the high-pass section of the crossover. Adjust it to be wide open (= no resistance), play some white noise (FM-tuner noise works very well) and adjust the pot so that the treble output is down just audibly. Live with that setting for a while to see if it's too much or not enough. Adjust the resistor higher or lower as desired for the sound you want. When you're satisfied, lift one wire from the pots, measure them and average those numbers, and order the resistor values you really need, then solder them in permanently. (I use the Mills noninductive wirewounds from Michael Persy.)

Remember, if you install these resistors AFTER the crossover caps, etc., you'll change the filter point of the crossover.

BTW, if your speaker is ported, you can run the pot's wires outside the box so you can adjust them without opening the boxes.

I've done this very thing to my car's system and also to my main home speakers; it works very well. In fact, I'm about to remove a couple pots from my car system so e-mail me if you want them for the cost of postage.
.

Have you considered the possibility that the "bright" might be from the room surfaces and/or speaker positioning?

Thank to Jeffreybehr, Gs5556 and Audio999 for their comments and suggestions. The Andras haven't crossover (the drivers are directly connected to their imputs terminals). I think it is a good idea to use potentioneters intead of fixed resistors. NMT 1000 ohms pots (how many watts?)? Where can acquire them Jeffreybehr? I will take in consideration the room surface and the wall reflexions as well as speakers placements. Thanks again.