Lowther speakers for Fisher X-202-B?

Perhaps I made my post sound a bit to negative.

I use Lowthers, and like them very much.

I was just trying to point out that there have been changes in the last couple of years, and maybe some people hadn't heard the newer versions, which are better than the old.

However, the situation with the cabinets is still a problem in most cases. These problems can be overcome with some thought and application of known technology.

thanks for the responses! let me add another question, which as I see on some past posts is widely debated: do you prefer the lowther or fostex drivers? i could pick up the cain abby speakers for even less than the lowthers, which do you prefer and why? the fisher is not heavy on the bass, so maybe, just maybe, the lowthers would be overly bright.

Both Fostex and Lowther are good drivers. Some will prefer the Fostex, and some will prefer the Lowther.

Personally, I found the Lowther drivers to be what I preferred.

Generally the Fostex drivers are a little bit less in sensitivity, with about 94db being typical for them, whereas the Lowther drivers have models going up to 99.5db sensitivity. This may be useful if the amp's power levels are quite low. The Fostex will be just fine with anything about 8 wpc and over.

I think that the Lowther has more detail and is a bit faster and more transparent, but they cost alot more than the Fostex.

There are proponents of both brands, and ultimately you would have to decide which you like, and which suits your budget and system best.

I'd like to add that the 1.3 bass-reflex box for the PM2C is not really the right design for Lowther drivers. The Lowther is designed to have the rear-wave loaded into a back-horn type enclosure, or a Voigt Pipe(Cain&Cain Abbey type).

Also, the PM2C is the "budget" Lowther, and has lower sensitivity around the same level as the Fostex, has ceramic magnets, and offers less detail, speed, and transparency than the higher Lowther models. But they are still good speakers. They would be probably more similar to the performance of the Fostex models.

Twl, if I prefer a more mellow sound, is the Fostex the better choice? not that I don't want accurate speakers, but I don't neccessarily wan't every flaw on a recording to be revealed.

Jtn the Cain&Cain Abbys are terrific musical instruments.
I spent several hrs auditioning them. You can listen to these for hours without fatigue.They aren't rolled off,neither are they hyper reality. The Fostex has a very natural sound.It's cone is made from banana plant fiber, it should sound natural LOL.

None of these speakers will suit a rock & roller. Anyone into jazz,vocals, instrumental or classical music owes it to themselves to take a listen. I'm done with speakers that use crossovers. I never realised there was so much information and emotion in the music that's stripped by some crossovers. The only speakers with crossovers I've heard that come close in coherency and natural timing are Green Mountain Audio Europas.

Single driver/crossoverless type speakers really do make some speakers sound like a blanket was tossed over them.. no matter their cost!

Give these speakers a good source and be prepared to have your mind blowed! I find good old fashion copper speaker wires do the trick as well. These speakers don't need silver..I already made that mistake!

As always listen for yourself.