2. speakers
  3. 1115402301

Proac Response 1sc hookup

Hi,

I just received a very nice set of Response 1sc's (no manual though) and I have what is probably a dumb question. These have what I assume are the stock jumpers between the 2 sets of binding posts and these prevent me from tightening the posts enough to grip a spade lug on my single wire cables. Luckily I have another pair of cables with bananas that I can use but I was hoping someone could explain what I'm doing wrong.

Thanks,
Wes
classic95
classic95 OP
52 posts
 
Thanks Camadeco,

Let me elaborate, it's more like the jumpers are so thick they won't let the binding post tighten down enough to actually grip the spade. I'm not sure if that's what you are replying to. The speakers do benefit from biwiring?

Wes
chadnliz
3,736 posts
 
BI WIRE BI WIRE BI WIRE
gjrad
145 posts
 
I have the 1SC and 2.5 with the same issue, solution, get rid the the cheap pins and either get quality jumpers or Bi Wire.
springbok10
711 posts
 
My 1s sound infintely better with Bi-wires. No question. But, if you must use jumpers, I got Rhodium pins from my Proac dealer and the the pins are placed through the top binding posts to firmly contact, but not screwed in, to allow the bottom spades to connect. Otherwise, use bananas.
artg
362 posts
 
another vote for the obvious - bi-wire!
More to discover